71 modules from Allied Telesis
Allied Telesis's MIBs here cover its AT-branded enterprise switches and routers, including the CentreCOM line and compact models like the GS950/8, plus modular chassis gear tracked through board and slot inventory. The recurring subject matter is heavy on Layer 2 resilience and physical-layer detail: EPSR and G.8032 ring protection, switch stacking, fiber transceiver signal monitoring (Tx/Rx power, DOM), PTP clock sync, VLAN/trunk configuration, and legacy WAN interfaces like ISDN PRI and DS3. If you run Allied Telesis switches in a ring or stack topology, look here for the AT-EPSR, AT-G8032v2, and AtiStackInfo MIBs that expose failover and topology state the standard IETF bridge MIBs don't cover. Most modules use the AT- prefix, but note the older AtiStackInfo and CentreCOM-prefixed modules reflect earlier naming from before the AT- convention was standardized.
| Module | Description |
|---|---|
| AT-ALMMON-MIB | Manages alarm monitoring configuration and active alarm state on Allied Telesis network switches and routers. |
| AT-ATMF-MIB | Covers objects for network-wide device discovery, provisioning, and topology within the Allied Telesis Management Framework (AMF). |
| AT-BOARDS-MIB | Reports installed line-card and expansion board inventory, status, and configuration on Allied Telesis modular chassis devices. |
| AT-BRI-MIB | Manages ISDN Basic Rate Interface (BRI) configuration and call statistics on Allied Telesis router platforms. |
| AT-CHASSIS-MIB | Monitors Allied Telesis modular chassis hardware, including slot occupancy, backplane status, and power budget. |
| AT-DHCP-MIB | Manages DHCP server address pools, lease bindings, and statistics on Allied Telesis routers and layer-3 switches. |
| AT-DHCPSN-MIB | Monitors DHCP snooping binding tables and trusted/untrusted port configuration on Allied Telesis switches. |
| AT-DNS-CLIENT-MIB | Manages DNS client resolver configuration including server addresses and domain search lists on Allied Telesis devices. |
| AT-DOS-MIB | MIB for managing Denial of Service attack defense features on Allied Telesis network switches |
| AT-DS3-MIB | Monitors DS3/T3 interface performance counters, framing errors, and alarm conditions on Allied Telesis WAN modules. |
| AT-ENVMON-MIB | Monitors environmental sensors including temperature, fan speed, and power supply status on Allied Telesis switches. |
| AT-ENVMONv2-MIB | Provides enhanced environmental monitoring with threshold alerts for temperature, fans, and PSU health on Allied Telesis platforms. |
| AT-EPSR-MIB | Manages Ethernet Protection Switching Ring (EPSR) topology, ring health, and failover state on Allied Telesis switches. |
| AT-EPSRv2-MIB | Provides enhanced EPSR v2 ring protection configuration and fault notification on Allied Telesis network switches. |
| AT-ETH-MIB | Manages Ethernet interface parameters, auto-negotiation settings, and per-port statistics on Allied Telesis switches. |
| AT-FIBER-MONITORING-MIB | Monitors fiber optic transceiver signal levels, Tx/Rx power, and DOM thresholds on Allied Telesis SFP/SFP+ ports. |
| AT-FILE-MIB | Manages flash file system operations including file listing, transfer, and deletion on Allied Telesis network devices. |
| AT-FILEv2-MIB | Provides enhanced file system management including firmware and configuration file operations on Allied Telesis platforms. |
| AT-FIREWALL-MIB | Manages stateful firewall policy rules, connection tracking tables, and packet filter statistics on Allied Telesis security gateways. |
| AT-FLASH-MIB | Monitors flash memory usage, available space, and firmware image information on Allied Telesis switches and routers. |
| AT-G8032v2-MIB | Manages ITU-T G.8032 Ethernet Ring Protection Switching v2 instances and ring node states on Allied Telesis devices. |
| AT-GS950-16-MIB | Provides management objects specific to the Allied Telesis GS950/16 16-port Gigabit smart switch. |
| AT-GS950-24-MIB | Provides management objects specific to the Allied Telesis GS950/24 24-port Gigabit smart switch. |
| AT-GS950-8-MIB | Provides management objects specific to the Allied Telesis GS950/8 8-port Gigabit smart switch. |
| AT-HHM-MIB | Manages Allied Telesis Hardware Health Monitoring, tracking component failures and proactive fault notifications. |
| AT-IGMP-MIB | Manages IGMP snooping and proxy configuration, group membership tables, and multicast forwarding on Allied Telesis switches. |
| AT-INSTALL-MIB | Manages software installation, firmware upgrade procedures, and boot configuration on Allied Telesis network equipment. |
| AT-INTERFACES-MIB | Provides extended interface management objects supplementing IF-MIB for Allied Telesis physical and logical interfaces. |
| AT-IP-MIB | Manages IP routing configuration, ARP tables, and layer-3 interface parameters on Allied Telesis routers and switches. |
| AT-ISDN-MIB | Manages ISDN interface configuration, B-channel status, and call connection statistics on Allied Telesis router products. |
| AT-LB-MIB | Manages load balancing policy, server pool health, and traffic distribution statistics on Allied Telesis load-balancing devices. |
| AT-LICENSE-MIB | Tracks software feature license keys, activation status, and entitlement details on Allied Telesis network devices. |
| AT-LINKMON-MIB | Monitors link health, continuity check status, and uptime statistics for network connections on Allied Telesis devices. |
| AT-LINKTRAP-MIB | Defines link state change traps and associated notification objects for Allied Telesis network interfaces. |
| AT-LOADER-MIB | Manages boot loader configuration, firmware image selection, and startup parameter settings on Allied Telesis devices. |
| AT-LOG-MIB | Manages system logging configuration, log buffer size, and retrieval of log entries on Allied Telesis network equipment. |
| AT-LOOPPROTECT-MIB | Monitors and controls loop protection mechanisms that detect and disable ports with forwarding loops on Allied Telesis switches. |
| AT-MIBVERSION-MIB | Reports the version identifier and release date of the MIB suite currently running on Allied Telesis network devices. |
| AT-NTP-MIB | Manages NTP client/server configuration, clock synchronization status, and NTP peer associations on Allied Telesis devices. |
| AT-PAE-MIB | Manages IEEE 802.1X Port Access Entity authentication, RADIUS authentication settings, and supplicant status on Allied Telesis switches. |
| AT-PIM-MIB | Manages Protocol Independent Multicast (PIM) interface configuration, neighbor adjacencies, and multicast routing on Allied Telesis devices. |
| AT-PING-MIB | Provides SNMP-triggered ICMP ping test capability with configurable target, packet count, and result reporting on Allied Telesis devices. |
| AT-PLUGGABLE-DIAGNOSTICS-MIB | Reports diagnostic data for pluggable transceivers (SFP/QSFP) including temperature, voltage, and optical power on Allied Telesis devices. |
| AT-PRI-MIB | Manages ISDN Primary Rate Interface (PRI) T1/E1 configuration, D-channel status, and call statistics on Allied Telesis WAN modules. |
| AT-PRODUCT-MIB | Defines the Allied Telesis product OID registry, enumerating hardware platform identifiers for all Allied Telesis device families. |
| AT-PTP-MIB | Manages IEEE 1588 Precision Time Protocol (PTP) clock configuration, port states, and synchronization quality on Allied Telesis devices. |
| AT-PVSTPM-MIB | Manages Per-VLAN Spanning Tree Protocol (PVST+) instance configuration and port state on Allied Telesis LAN switches. |
| AT-QOS-MIB | Manages Quality of Service policy maps, traffic classification, and queuing parameters on Allied Telesis network devices. |
| AT-QOSv2-MIB | Provides enhanced QoS v2 policy configuration and per-class statistics for Allied Telesis switches and routers. |
| AT-RESOURCE-MIB | Monitors CPU utilization, memory usage, and system resource consumption on Allied Telesis network platforms. |
| AT-RG600-MIB | Provides management objects for the Allied Telesis RG600 family residential gateway devices, covering WAN, LAN, and DSL status. |
| AT-SETUP-MIB | Manages initial device setup parameters including hostname, IP configuration, and access credentials on Allied Telesis equipment. |
| AT-SMI-MIB | Defines the Structure of Management Information (SMI) and root OID hierarchy for all Allied Telesis enterprise MIBs. |
| AT-STACK-MIB | Manages Allied Telesis stacking topology, member roles, inter-switch links, and virtual chassis configuration. |
| AT-SWITCH-MIB | Provides core switch management objects for port configuration, MAC address tables, and VLAN membership on Allied Telesis switches. |
| AT-SYSINFO-MIB | Reports system identification information including model name, firmware version, and hardware revision on Allied Telesis devices. |
| AT-TRIGGER-MIB | Manages event trigger and threshold rules for automated SNMP notifications on Allied Telesis network devices. |
| AT-TTY-MIB | Manages TTY/terminal line configuration and session statistics for console and auxiliary ports on Allied Telesis devices. |
| AT-UDLD-MIB | Manages Uni-Directional Link Detection (UDLD) protocol configuration and unidirectional fault detection on Allied Telesis switch ports. |
| AT-UFO-MIB | Manages Allied Telesis Universal Fiber Optic (UFO) transceiver monitoring and alarm configuration on fiber interfaces. |
| AT-USER-MIB | Manages local user account credentials, privilege levels, and login session tracking on Allied Telesis network devices. |
| AT-VCSTACK-MIB | Manages Allied Telesis VCStack virtual chassis stacking, reporting member switch roles, VCStack IDs, and link health. |
| AT-VLAN-MIB | Manages VLAN creation, port membership, tagging mode, and 802.1Q trunk configuration on Allied Telesis LAN switches. |
| AT-XEM-MIB | Manages eXpandable Ethernet Module (XEM) line card status, port configuration, and performance on Allied Telesis modular switches. |
| AtiEdgeSwitch-MIB | Manages Allied Telesis edge switches including port, VLAN, and spanning tree configuration. |
| AtiStackInfo-MIB | Reports stacking topology, member switch IDs, and inter-unit link status for Allied Telesyn stackable switch systems. |
| AtiSwitch-MIB | Manages core switch configuration including port speed, duplex, storm control, and QoS on Allied Telesyn switches. |
| CENTRECOM-PORT-MIB | Manages physical port configuration and status for Allied Telesis CentreCOM switches. |
| CENTRECOM-QOS-MIB | Manages QoS queue scheduling and traffic classification on Allied Telesis CentreCOM switches. |
| CENTRECOM-SYSTEM-MIB | Monitors system-level parameters including CPU, memory, and firmware on Allied Telesis CentreCOM devices. |
| CENTRECOM-VLAN-MIB | Manages IEEE 802.1Q VLAN configuration and port membership on Allied Telesis CentreCOM switches. |