Description: Returns or sets the device behavior when this output bin condition causes printing to stop. cCancelJob - The device cancels the job. cOutbinFullOverride - The device sends subsequent media to the overflow bin. cOutbinAttentionOverride - The device ignores the attention condition and continues printing. cBinderAttentionOverride - The device ignores the binder attention condition and continues printing. Additional information: This object describes the action that is performed when the JOB-OUTPUT-AUTO-CONTINUE-TIMEOUT expires. The action performed by the CONTINUE object being set to eInitiateAction or the GO key being pressed on the control panel may cause different actions. See the CONTINUE object description for information on the actions that occur for those conditions. The cCancelJob item overrides the other two options, if it is set then the job will be canceled regardless of the other settings. If cJobCancel is not set then cBinFullOverride will cause the printer to use the overflow bin (Set by PML object OVERFLOW-BIN)in the case of a bin full condtion. If the cBinderAttentionOverride option is set then the finisher out warning will be displayed but ignored and jobs will continue to go to the finisher anyway. OUTBIN3 is the topmost bin on the output device. This bin replaces the left output bin on the base printer. OUTBIN4 through OUTBIN11 are the additional 8 bins supplied by the MBM8 device. NOTE: Because HP is marketing a device with a max of 9 bins (MBM8) the OUTBIN-OVERRIDE-MODE objects are 3-11 but the external device specification requires support of up to 315 output bins. Therefore if these bins exist above 11, then the coresponding objects will also exist OUTBIN12-OVERRIDE-MODE through OUTBIN317-OVERRIDE-MODE. The data for this object is stored in NVRAM.