| OID symbolic | OID numeric | Type | Access | Description |
|---|
| ciscoVoiceInterfaceMIB | 1.3.6.1.4.1.9.9.64 | | | Common Voice Interface MIB module.
The MIB module manages the common voice related
parameters for both voice analog and ISDN interfaces. |
| cvIfObjects | 1.3.6.1.4.1.9.9.64.1 | | | |
| cvIfCfgObjects | 1.3.6.1.4.1.9.9.64.1.1 | | | |
| cvIfCfgTable | 1.3.6.1.4.1.9.9.64.1.1.1 | | not-accessible | The Voice Common Configuration Table. It contains
information about the voice related configuration
parameters for both analog and digital telephony
interfaces. |
| cvIfCfgEntry | 1.3.6.1.4.1.9.9.64.1.1.1.1 | | not-accessible | An entry in the configuration table for each voice analog
interface or voice feature associated ISDN D channel.
The entry is automatically created when a voice analog
interface hardware is found or ISDN D channel is
configured and the ISDN associated voice support hardware
is detected by the managed system.
For the ISDN D channel associated entry, the entry
is deleted after ISDN D channel is removed. |
| T/F cvIfCfgNoiseRegEnable | 1.3.6.1.4.1.9.9.64.1.1.1.1.1 | TruthValue | read-write | The object indicates whether or not the background noise
should be played to fill silence gaps if VAD is
activated.
The default value of this object is enabled. |
| T/F cvIfCfgNonLinearProcEnable | 1.3.6.1.4.1.9.9.64.1.1.1.1.2 | TruthValue | read-write | The object indicates whether or not the Nonlinear
Processing is enabled for the interface.
The default value of this object is enabled. |
| I32 cvIfCfgMusicOnHoldThreshold | 1.3.6.1.4.1.9.9.64.1.1.1.1.3 | Integer32 | read-write | The object specifies the Music On Hold Threshold for
the interface.
The default value of this object is -38 dBm. |
| I32 cvIfCfgInGain | 1.3.6.1.4.1.9.9.64.1.1.1.1.4 | Integer32 | read-write | This object contains the amount of gain inserted at the
receiver side of the interface. The input gain settings
only define a gain/loss relative to the 0 dB setting.
The absolute loss at the 0 dB setting could be
implementation dependent based on the desired network
loss plan.
The default value of this object is 0 dB (decibel). |
| I32 cvIfCfgOutAttn | 1.3.6.1.4.1.9.9.64.1.1.1.1.5 | Integer32 | read-write | This object contains the amount of attenuation inserted
at the transmit side of the interface.
The output attenuation settings only define a loss
relative to the 0 dB setting.
The absolute loss at the 0 dB setting could be
implementation dependent based on the desired network
loss plan.
The default value of this object is 0 dB (decibel). |
| T/F cvIfCfgEchoCancelEnable | 1.3.6.1.4.1.9.9.64.1.1.1.1.6 | TruthValue | read-write | The object specifies whether or not the Echo Cancellation
is enabled for the interface.
The default value of this object is enabled. |
| INT cvIfCfgEchoCancelCoverage | 1.3.6.1.4.1.9.9.64.1.1.1.1.7 | INTEGER | read-write | The object specifies the Echo Canceller coverage for
the interface. This object is valid if the
cvIfCfgEchoCancelEnable object is 'true'.
echoCanceller8ms - 8 millisecs echo canceller coverage.
echoCanceller16ms - 16 millisecs echo canceller coverage.
echoCanceller24ms - 24 millisecs echo canceller coverage.
echoCanceller32ms - 32 millisecs echo canceller coverage.
echoCanceller48ms - 48 millisecs echo canceller coverage.
echoCanceller64ms - 64 millisecs echo canceller coverage.
echoCanceller80ms - 80 millisecs echo canceller coverage.
echoCanceller96ms - 96 millisecs echo canceller coverage.
echoCanceller112ms - 112 millisecs echo canceller coverage.
echoCanceller128ms - 128 millisecs echo canceller coverage.
The default value of this object is echoCanceller8ms or
echoCanceller64ms, depending on the particular echo
canceller. |
| INT cvIfCfgConnectionMode | 1.3.6.1.4.1.9.9.64.1.1.1.1.8 | INTEGER | read-write | The object indicates the connection mode of the interface.
normal - the interface acts normally to handle incoming
and outgoing call.
trunk - the interface acts in trunking mode. trunking mode
causes two interfaces (on either the same or
different routers) to be always conferenced
together, and for telephony signaling to be passed
transparently through the VoIP system rather than
trapped and interpreted by the session application
on the router(s).
plar - the interface acts in PLAR (private line automatic
ringdown) mode. PLAR is handled by associating a
peer directly with an interface such that when the
interface goes off-hook, that peer is used to
setup the second call leg and conference them
together without the caller having to dial any
digits.
tieline- the interface acts in tie-line mode. This
specifies a connection that emulates a temporary
tie-line trunk to a PBX. A tie-line connection is
automatically set up for each call and torn down
when the call ends. |
| STR cvIfCfgConnectionNumber | 1.3.6.1.4.1.9.9.64.1.1.1.1.9 | DisplayString | read-write | This is the E.164 phone number that is used to
establish connection with trunking mode or PLAR mode.
If the cvIfCfgConnectionMode is 'normal', then this
object will be a zero length string. |
| I32 cvIfCfgInitialDigitTimeOut | 1.3.6.1.4.1.9.9.64.1.1.1.1.10 | Integer32 | read-write | This is the initial digit timeout that indicates the amount
of time the managed system waits for an initial input digit
from the caller. The timer is activated when the call is
accepted and is deactivated upon digit input. If the timer
expires, the caller is signaled through the appropriate
tone and the call is abandoned. The value of zero disables
the timer.
The default value of this object is 10 seconds. |
| I32 cvIfCfgInterDigitTimeOut | 1.3.6.1.4.1.9.9.64.1.1.1.1.11 | Integer32 | read-write | This is the inter-digit timeout that indicates the amount
of time the managed system waits for a subsequent input
digit from the caller. The timer is started upon receipt
of an input digit and restarted as each digit is received
until the destination address is identified. If the timer
expires and no destination address is identified, the
caller is signaled through the appropriate tone and the
call is abandoned. The value of zero disables the timer.
The default value of this object is 10 seconds. |
| COU cvIfCfgRegionalTone | 1.3.6.1.4.1.9.9.64.1.1.1.1.12 | CountryCode | read-write | This object contains the country specific setting
for the tone, ring, cadence parameters to be used by
this interface. |
| INT cvIfCfgEchoCancelWorstERL | 1.3.6.1.4.1.9.9.64.1.1.1.1.13 | INTEGER | read-write | The object specifies the worst case Echo Return Loss for
which the echo canceller must operate. To some echo
cancellers this object may not apply. This object is
valid if the cvIfCfgEchoCancelEnable object is 'true'.
echoCancellerWorstERL6dB - 6 decibels worst case ERL.
echoCancellerWorstERL3dB - 3 decibels worst case ERL.
echoCancellerWorstERL0dB - 0 decibels worst case ERL.
echoCancellerWorstERLUnknown - the object does not apply
to this echo canceller.
The default value of this object is
echoCancellerWorstERL6dB unless
echoCancellerWorstERLUnknown is appropriate because
the echo canceller is not configurable by this object. |
| INT cvIfCfgEchoCanceller | 1.3.6.1.4.1.9.9.64.1.1.1.1.14 | INTEGER | read-only | The object specifies which echo canceller is present
on the interface.
echoCancellerStandard - for this echo canceller valid
values of cvIfCfgEchoCancelCoverage are echoCanceller8ms
through echoCanceller32ms; cvIfCfgEchoCancelWorstERL is
not valid.
echoCancellerExtended - for this echo canceller valid
values of cvIfCfgEchoCancelCoverage are echoCanceller24ms
through echoCanceller128ms; cvIfCfgEchoCancelWorstERL is
valid. |
| cvIfConformance | 1.3.6.1.4.1.9.9.64.2 | | | |
| cvIfCompliances | 1.3.6.1.4.1.9.9.64.2.1 | | | |
| cvIfCompliance | 1.3.6.1.4.1.9.9.64.2.1.1 | | | The compliance statement for entities which
implement the Cisco Voice Interface MIB |
| cvIfGroups | 1.3.6.1.4.1.9.9.64.2.2 | | | |
| cvIfGroup | 1.3.6.1.4.1.9.9.64.2.2.1 | | | A collection of objects providing the Common Voice
parameter related configuration for both analog and
digital voice interfaces. |
| cvIfConnectionGroup | 1.3.6.1.4.1.9.9.64.2.2.2 | | | A collection of objects providing trunking or PLAR
(private line automatic ringdown) related configuration
for voice analog interfaces. |
