| OID symbolic | OID numeric | Type | Access | Description |
|---|
| appnTrapMIB | 1.3.6.1.2.1.34.4.0 | | | This MIB module defines notifications to be generated by
network devices with APPN capabilities. It presupposes
support for the APPN MIB. It also presupposes
support for the DLUR MIB for implementations
that support the DLUR-related groups. |
| NTF appnIsrAccountingDataTrap | 1.3.6.1.2.1.34.4.0.1 | | | When it has been enabled, this notification is generated by an
APPN node whenever an ISR session passing through the node is
taken down, regardless of whether the session went down
normally or abnormally. Its purpose is to allow a management
application (primarily an accounting application) that is
monitoring the ISR counts to receive the final values of these
counts, so that the application can properly account for the
amounts the counts were incremented since the last time the
application polled them. The appnIsInSessUpTime object
provides the total amount of time that the session was active.
This notification is not a substitute for polling the ISR
counts. In particular, the count values reported in this
notification cannot be assumed to be the complete totals for
the life of the session, since they may have wrapped while the
session was up.
The session to which the objects in this notification apply is
identified by the fully qualified CP name and PCID that make up
the table index. An instance of this notification will contain
exactly one instance of each of its objects, and these objects
will all belong to the same conceptual row of the
appnIsInTable.
Generation of this notification is controlled by the same
object in the APPN MIB, appnIsInGlobeCtrAdminStatus, that
controls whether the count objects themselves are being
incremented. |
| NTF appnLocalTgOperStateChangeTrap | 1.3.6.1.2.1.34.4.0.2 | | | When it has been enabled, this notification makes it possible
for an APPN topology application to get asynchronous
notifications of local TG operational state changes,
and thus to reduce the frequency with which it polls
for these changes.
This notification is sent whenever there is a change to
the appnLocalTgOperational object in a row of the
appnLocalTgTable. This notification is only sent for row
creation if the row is created with a value of 'true' for
appnLocalTgOperational. This notification is only sent for
row deletion if the last value of appnLocalTgOperational was
'true'. In this case, the value of appnLocalTgOperational
in the notification shall be 'false', since the deletion of
a row indicates that the TG is no longer operational.
The notification is more than a simple 'poll me now' indication.
It carries both a count of local TG topology changes, and the
current operational state itself. The count of changes allows an
application to detect lost notifications, either when polling
or upon receiving a subsequent notification, at which point it
knows it must retrieve the entire appnLocalTgTable again.
This is the same count as used in the appnLocalCpCpStateChangeTrap.
A lost notification could indicate a local TG CP-CP session state
change or an operational state change.
Generation of this notification is controlled by the
appnTrapControl object. |
| NTF appnLocalTgCpCpChangeTrap | 1.3.6.1.2.1.34.4.0.3 | | | When it has been enabled, this notification makes it possible
for an APPN topology application to get asynchronous
notifications of local TG control-point to control-point (CP-CP)
session state changes, and thus to reduce the
frequency with which it polls for these changes.
This notification is sent whenever there is a change to
the appnLocalTgCpCpSession object but NOT the
appnLocalTgOperational object in a row of the appnLocalTgTable.
This notification is never sent for appnLocalTgTable row
creation or deletion.
The notification is more than a simple 'poll me now' indication.
It carries both a count of local TG topology changes, and the
current CP-CP session state itself. The count of changes allows
an application to detect lost notifications, either when polling
or upon receiving a subsequent notification, at which point it
knows it must retrieve the entire appnLocalTgTable again. This
is the same count as used in the appnLocalTgOperStateChangeTrap.
A lost notification could indicate a local TG CP-CP session
state change or an operational state change.
Generation of this notification is controlled by the
appnTrapControl object. |
| NTF appnPortOperStateChangeTrap | 1.3.6.1.2.1.34.4.0.4 | | | When it has been enabled, this notification makes it possible
for an APPN topology application to get asynchronous
notifications of port operational state changes, and thus to
reduce the frequency with which it polls for these changes.
This notification is only sent when a appnPortOperState has
transitioned to a value of 'active' or 'inactive'.
This notification is sent whenever there is a appnPortOperState
object transition to 'inactive' or 'active' state in the
appnPortTable. This notification is only sent for row creation
if the row is created with a value of 'active' for
appnPortOperState. This notification is only sent for
row deletion if the last value of appnPortOperState was
'active'. In this case, the value of appnPortOperState
in the notification shall be 'inactive', since the deletion of
a row indicates that the port is no longer active.
The notification is more than a simple 'poll me now' indication.
It carries both a count of port table changes, and the
operational state itself. The count of changes allows an
application to detect lost notifications, either when polling
or upon receiving a subsequent notification, at which point
it knows it must retrieve the entire appnPortTable again.
Generation of this notification is controlled by the
appnTrapControl object. |
| NTF appnLsOperStateChangeTrap | 1.3.6.1.2.1.34.4.0.5 | | | When it has been enabled, this notification makes it possible
for an APPN topology application to get asynchronous
notifications of link station operational state changes, and
thus to reduce the frequency with which it polls for these
changes. This notification is only sent when a appnLsOperState
has transitioned to a value of 'active' or 'inactive'.
This notification is sent whenever there is a appnLsOperState
object transition to 'inactive' or 'active' state in the
appnLsTable. This notification is only sent for row creation
if the row is created with a value of 'active' for
appnLsOperState. This notification is only sent for
row deletion if the last value of appnLsOperState was
'active'. In this case, the value of appnLsOperState
in the notification shall be 'inactive', since the deletion of
a row indicates that the link station is no longer active.
The notification is more than a simple 'poll me now' indication.
It carries both a count of link station table changes, and the
operational state itself. The count of changes allows an
application to detect lost notifications, either when polling
or upon receiving a subsequent notification, at which point it
knows it must retrieve the entire appnLsTable again.
Generation of this notification is controlled by the
appnTrapControl object. |
| NTF dlurDlusStateChangeTrap | 1.3.6.1.2.1.34.4.0.6 | | | When it has been enabled, this notification makes it possible
for an APPN topology application to get asynchronous
notifications of DLUR-DLUS session changes, and thus to reduce
the frequency with which it polls for these changes.
This notification is sent whenever there is a dlurDlusSessnStatus
object transition to 'inactive' or 'active' state in the
dlurDlusTable. This notification is only sent for row creation
if the row is created with a value of 'active' for
dlurDlusSessnStatus. This notification is only sent for
row deletion if the last value of dlurDlusSessnStatus was
'active'. In this case, the value of dlurDlusSessnStatus
in the notification shall be 'inactive', since the deletion of
a row indicates that the session is no longer active.
The notification is more than a simple 'poll me now' indication.
It carries both a count of DLUR-DLUS table changes, and the
session status itself. The count of changes allows an
application to detect lost notifications, either when polling
or upon receiving a subsequent notification, at which point it
knows it must retrieve the entire dlurDlusTable again.
Generation of this notification is controlled by the
appnTrapControl object. |
| appnTrapObjects | 1.3.6.1.2.1.34.4.1.7 | | | |
| BIT appnTrapControl | 1.3.6.1.2.1.34.4.1.7.1 | Bits | read-write | An object to turn APPN notification generation on and off.
Setting a notification type's bit to 1 enables generation of
notifications of that type, subject to further filtering
resulting from entries in the snmpNotificationMIB. Setting
this bit to 0 disables generation of notifications of that
type.
Note that generation of the appnIsrAccountingDataTrap is
controlled by the appnIsInGlobeCtrAdminStatus object in
the APPN MIB: if counts of intermediate session traffic
are being kept at all, then the notification is also enabled. |
| C32 appnLocalTgTableChangesEx | 1.3.6.1.2.1.34.4.1.7.2 | Counter32 | read-only | A count of the number of times a row in the appnLocalTgTable
has changed status since the APPN node was last reinitialized.
This counter is incremented whenever a condition is detected
that would cause a appnLocalTgOperStateChangeTrap or
appnLocalTgCpCpChangeTrap notification to be sent, whether
or not those notifications are enabled. |
| C32 appnPortTableChanges | 1.3.6.1.2.1.34.4.1.7.3 | Counter32 | read-only | A count of the number of times a row in the appnPortTable
has changed status since the APPN node was last reinitialized.
This counter is incremented whenever a condition is detected
that would cause a appnPortOperStateChangeTrap notification
to be sent, whether or not this notification is enabled. |
| C32 appnLsTableChanges | 1.3.6.1.2.1.34.4.1.7.4 | Counter32 | read-only | A count of the number of times a row in the appnLsTable
has changed status since the APPN node was last reinitialized.
This counter is incremented whenever a condition is detected
that would cause a appnLsOperStateChangeTrap notification
to be sent, whether or not this notification is enabled. |
| C32 dlurDlusTableChanges | 1.3.6.1.2.1.34.4.1.7.5 | Counter32 | read-only | A count of the number of times a row in the dlurDlusTable
has changed status since the APPN node was last reinitialized.
This counter is incremented whenever a condition is detected
that would cause a dlurDlusStateChangeTrap notification
to be sent, whether or not this notification is enabled. |
| appnTrapMibCompliance | 1.3.6.1.2.1.34.4.3.1.2 | | | The compliance statement for the SNMP entities that
implement the APPN-TRAP-MIB. |
| appnTrapMibIsrNotifGroup | 1.3.6.1.2.1.34.4.3.2.21 | | | A notification for reporting the final values of the
APPN MIB's ISR counters. |
| appnTrapMibTopoConfGroup | 1.3.6.1.2.1.34.4.3.2.22 | | | A collection of objects for reducing the polling
associated with the local topology tables in the
APPN MIB. Nodes that implement this group SHALL
also implement the appnTrapMibTopoNotifGroup. |
| appnTrapMibTopoNotifGroup | 1.3.6.1.2.1.34.4.3.2.23 | | | A collection of notifications for reducing the polling
associated with the local topology tables in the
APPN MIB. Nodes that implement this group SHALL
also implement the appnTrapMibTopoConfGroup. |
| appnTrapMibDlurConfGroup | 1.3.6.1.2.1.34.4.3.2.24 | | | A collection of objects for reducing the polling
associated with the dlurDlusTable in the DLUR
MIB. Nodes that implement this group SHALL also
implement the appnTrapMibDlurNotifGroup. |
| appnTrapMibDlurNotifGroup | 1.3.6.1.2.1.34.4.3.2.25 | | | A notification for reducing the polling associated
with the dlurDlusTable in the DLUR MIB. Nodes that
implement this group SHALL also implement the
appnTrapMibDlurConfGroup. |
