Description: This object is used to send device-specific data to the paper handling device. The meaning of the device- specific command is dependent on the paper handling device and must be specified in the POS. If the paper handling device does not accept the command, then an will be returned. If the device accepts the command, it may still be processing the command after the response has been returned. Depending on the device, the application may need to query PHDx-DEVICE-MEMORY to see when the command has completed. Additional information: For Tlatoani, the device-specific binary strings that may be sent to the paper handling device are described below. The value returned in reponse to the set request is the HCO mode (note that it is the current mode, which is not necessarily the same as the mode just set). The format of the response is the same as the command format, including the command byte. The general format of the binary string is: . The current HCO implementation does not require any . BYTE 1 is Command {Valid value: 1 .. 2} 1 = Set HCO Mode 2 = Return HCO Mode BYTE 2 is Set HCO Mode Option {Valid values: 1 .. 4} 1 = Stacker 2 = Separator 3 = Collator <> 4 = Mailbox Mailbox 1 is the TOP mailbox. Example for setting the mode: BYTE number: 1 2 1 1 Set mode to Stacker. 1 2 Set mode to Separator. 1 4 Set mode to Mailbox. Example for getting the current mode: BYTE number: 1 2 2 0 Command to return the mode. 2 1 Current mode is Stacker. 2 2 Current mode is Separator. 2 4 Current mode is Mailbox.