All MIBs › ZTE-AN-PPPOE-SNOOPING-MIB
Organization: ZTE Corporation
Last Updated: 2019-01-23
Category: ZTE Access Node (ZTE-AN) Management
Description: Manages ZTE access node PPPoE snooping to monitor and control subscriber PPPoE sessions.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ZTE-AN-PPPOE-SNOOPING-MIB?
ZTE-AN-PPPOE-SNOOPING-MIB is part of ZTE's Access Node family and implements PPPoE snooping, a feature that tracks and tags PPPoE session establishment at the access edge for subscriber accounting and security purposes. It exposes configuration for enabling snooping per port/VLAN and, presumably, state describing active PPPoE session bindings observed on the device. It is a software/protocol-state monitoring MIB: it confirms whether subscriber PPPoE sessions are being correctly tracked and tagged, which is used to detect subscriber connectivity problems or session-flood/fraud conditions rather than hardware faults. It builds on the PPPoE protocol standard (RFC 2516). It is typically deployed by broadband access operators for subscriber session visibility and anti-abuse protection on DSL/Ethernet access networks, where ZTE-AN-PPPOE-SNOOPING-MIB SNMP monitoring helps confirm session tracking remains accurate at the access edge.
IPNetwork Monitor allows you to monitor SNMP objects defined in ZTE-AN-PPPOE-SNOOPING-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- ZTE access node (DSLAM/OLT/Ethernet access switch)
Monitoring Examples
No concrete object names were available in the source for this module, so the following is inferred from module_desc rather than confirmed identifiers: an operator would enable snooping on a port or VLAN and then check a session-tracking table for the number of currently active PPPoE sessions along with their client MAC/session identifiers. An unexpected spike in session count on a single port could reveal a PPPoE session-flood attempt or a misbehaving CPE repeatedly reconnecting.
What Can Be Monitored
- PPPoE snooping enable state
- active PPPoE session count per port
- session client MAC/session-ID tracking
Imported Objects
From IF-MIB
| ifIndex | OBJECT-TYPE |
From INET-ADDRESS-MIB
| InetAddress | |
| InetAddressType |
From SNMPv2-CONF
| MODULE-COMPLIANCE | |
| OBJECT-GROUP |
From SNMPv2-SMI
| Integer32 | |
| MODULE-IDENTITY | |
| OBJECT-TYPE |
From SNMPv2-TC
| DateAndTime | |
| DisplayString | |
| MacAddress | |
| RowStatus |
From ZTE-AN-IF-MIB
| zxAnSubIfIndex | OBJECT-TYPE |
From ZTE-AN-SMI
| zxAnServiceSecurity | OBJECT-IDENTITY |
From ZTE-AN-TC-MIB
| VlanId |
OIDs
RFC description
Manages PPPoE snooping configuration and filtering on ZTE access network devices.
Start monitoring ZTE access node (DSLAM/OLT/Ethernet access switch) (PPPoE session-tracking/tagging status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.