WWP-SYSTEM-CONTROL-MIB

Description: Manages World Wide Packets system control operations including device reboot and software reset functions.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

This is a vendor-specific proprietary MIB from World Wide Packets (WWP) covering system control operations for its carrier Ethernet switches, including remotely triggered device reboot and software reset functions. It exposes control objects rather than passive counters, letting an operator command the device into a reset or reboot state through SNMP. This makes it directly relevant to hardware/software status monitoring: the state of these control objects (and the device's uptime after a reset) is a key signal of whether a previous reset was successful, whether the device is mid-recovery, or whether an unplanned reboot has occurred. It has no strong documented dependency on other MIBs beyond likely coexistence with standard MIB-II sysUpTime for confirming reset outcomes. It is typically deployed on WWP metro Ethernet switches where remote, out-of-band recovery from software faults is needed without physical site access. Network engineers evaluating or troubleshooting this functionality can download the WWP-SYSTEM-CONTROL-MIB file directly to load it into their MIB browser.

No sample_objects were provided for this module, so specific identifiers cannot be cited with confidence beyond what the short description and module_desc indicate: reboot and software reset control objects. A network operations team would write to the reboot/reset control object to recover a switch that has become unresponsive, then poll standard sysUpTime to confirm the device restarted successfully. If sysUpTime does not reset to a low value after the command is issued, that indicates the reboot command failed or the device hung during restart.

Configures system-level features including Rapid Spanning Tree Protocol (RSTP) and Link Aggregation Control Protocol (LACP) on World Wide Packets devices.