SLE-RIPng-MIB

MIB Reference — IPNetwork Monitor · Updated October 06, 2026

All MIBs › SLE-RIPng-MIB

Organization: HANASOFT

Last Updated: 2010--0-3-

Category: DASAN Networks SLE OLT Management, IP Routing Protocols

Description: Manages Hanasoft SLE OLT RIPng IPv6 routing protocol configuration and route redistribution.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

What Is SLE-RIPng-MIB?

SLE-RIPng-MIB is a vendor MIB from Hanasoft for its SLE OLT (Optical Line Terminal) product line, covering RIPng (RIP version 2 for IPv6) routing protocol configuration and route redistribution on the device. It exposes routing-protocol configuration data: RIPng interface settings, redistribution policy, and related routing parameters used to control how the OLT participates in IPv6 dynamic routing, rather than general hardware sensor data. In monitoring terms it is chiefly useful for confirming that RIPng is correctly configured and operational on relevant interfaces of the OLT, and for detecting misconfigured redistribution that could cause routing instability, rather than for reporting temperature, CPU, or power health. It depends conceptually on the standard IETF RIPng specification (RFC 2080) and likely on IF-MIB for interface association, since RIPng is configured per interface. It is typically deployed on Hanasoft SLE OLT platforms in FTTH/PON access networks where IPv6 dynamic routing via RIPng is required, and operators can download the SLE-RIPng-MIB file to load it into their MIB browser for this purpose.

IPNetwork Monitor allows you to monitor SNMP objects defined in SLE-RIPng-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.

Supported Devices

  • Hanasoft SLE OLT (Optical Line Terminal)

Monitoring Examples

No sample objects were provided for this module, so no concrete object or table names can be cited with confidence. In practice an operator would likely poll a RIPng interface configuration table to confirm which interfaces have RIPng enabled and to check redistribution or metric settings for correctness. Any specific object names beyond this general description would be speculative given the lack of grounding data.

What Can Be Monitored

  • RIPng interface enablement
  • route redistribution configuration
  • RIPng routing parameters
Imported Objects

From DASAN-SMI

sleMgmtOBJECT-IDENTITY

From INET-ADDRESS-MIB

InetAddress

From SLE-TC-MIB

SleControlRequestResultType
SleControlStatusType

From SNMPv2-CONF

NOTIFICATION-GROUP
OBJECT-GROUP

From SNMPv2-SMI

Gauge32
IpAddress
MODULE-IDENTITY
NOTIFICATION-TYPE
OBJECT-TYPE
TimeTicks
OIDs

RFC description

Manages RIPng (Routing Information Protocol Next Generation) for IPv6 routing, including default metrics and distance settings.

Start monitoring Hanasoft SLE OLT (Optical Line Terminal) (RIPng IPv6 routing configuration) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

Download SLE-RIPng-MIB