IBM2210-MIB

All MIBs › IBM2210-MIB

Category: Domain: WAN, Domain: WAN/TDM, Vendor: IBM

Description: IBM MIB for the IBM 2210 Nways Multiprotocol Router providing WAN and LAN interface management objects.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

What Is IBM2210-MIB?

IBM2210-MIB is IBM's enterprise MIB for the IBM 2210 Nways Multiprotocol Router, a legacy WAN/LAN routing platform, covering the networking hardware technology area. It organizes management objects into administrative, system, hardware, routing, and switching branches, reflecting a fairly comprehensive router management structure. Its monitoring value spans both hardware and software status: the hardware branch would expose board/module and interface hardware state, while the routing and switching branches expose protocol and forwarding status, together letting an administrator confirm the router's WAN/LAN interfaces and routing functions are operating correctly. As an IBM-specific MIB for a router product, it likely complements standard IETF interface and routing MIBs (IF-MIB, IP-MIB) present on the same device rather than replacing them. It is deployed on IBM 2210 routers, a product historically used for branch/WAN connectivity. Engineers can download the IBM2210-MIB file directly to load it into their MIB browser.

IPNetwork Monitor allows you to monitor SNMP objects defined in IBM2210-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.

Supported Devices

IBM 2210 Nways Multiprotocol Router

Monitoring Examples

Given only top-level branch names (ibm2210admin, ibm2210system, ibm2210hardware, ibm2210routing, ibm2210switching) were provided, a realistic drill-down would be hardware status objects under ibm2210hardwareinfo describing installed adapter cards and their operational state. An administrator would poll hardware status under ibm2210hardware to detect a WAN adapter card failure, and routing-branch objects to confirm expected routes are present, revealing connectivity loss on a branch-office link.

What Can Be Monitored

hardware/adapter status
system configuration state
routing table/protocol status
switching status

Imported Objects

From PROTEON-MIB

proElsSubSysEventMsg	OBJECT-TYPE
proElsTrapEvent	OBJECT-TYPE
proElsTrapSeqs	OBJECT-TYPE
proElsTrapSubSystem	OBJECT-TYPE

From RFC-1212

OBJECT-TYPE

From RFC-1215

TRAP-TYPE

From RFC1155-SMI

Counter
IpAddress
enterprises

From RFC1213-MIB

ifIndex

OIDs

OID symbolic	OID numeric	Type	Access	Description
proteon	1.3.6.1.4.1.1
proXfaceGenericTable	1.3.6.1.4.1.1.2		not-accessible	A table of information about each interface.
proXfaceGenericEntry	1.3.6.1.4.1.1.2.1		not-accessible	An entry containing objects to describe the interface.
INT proXfaceGenericType	1.3.6.1.4.1.1.2.1.1	INTEGER	read-only	The type of the interface, according to the internal net identifier.
INT proXfaceGenericCSR	1.3.6.1.4.1.1.2.1.2	INTEGER	read-only	The Command and Status Register address for the interface.
INT proXfaceGenericIntVec	1.3.6.1.4.1.1.2.1.3	INTEGER	read-only	The multi-bus interrupt vector for the interface.
INT proXfaceGenericMaintInt	1.3.6.1.4.1.1.2.1.4	INTEGER	read-only	The number of seconds before the next interface maintenance.
INT proXfaceGenericMaintLim	1.3.6.1.4.1.1.2.1.5	INTEGER	read-only	The number of maintenance check failures permitted before a self test is run.
INT proXfaceGenericNextTest	1.3.6.1.4.1.1.2.1.6	INTEGER	read-only	The number of seconds before the next self test.
INT proXfaceGenericNextMaint	1.3.6.1.4.1.1.2.1.7	INTEGER	read-only	The number of seconds between maintenance checks.
CTR proXfaceGenericMaintCnt	1.3.6.1.4.1.1.2.1.8	Counter	read-only	The number of failed maintenance checks since the last successful maintenance check.
CTR proXfaceGenericMaintFails	1.3.6.1.4.1.1.2.1.9	Counter	read-only	The total number of maintenance failures on this interface.
CTR proXfaceGenericTestPasses	1.3.6.1.4.1.1.2.1.10	Counter	read-only	The total number of self test successes on this interface.
CTR proXfaceGenericTestFails	1.3.6.1.4.1.1.2.1.11	Counter	read-only	The total number of self test failures on this interface.
INT proXfaceGenericModuleId	1.3.6.1.4.1.1.2.1.12	INTEGER	read-only	The module identifier of this interface, this object is relevant only to the CNX and DNX platforms. It uniquely identifies the interface card-type. It will always be '0' for the IBM2210 platform.
proto	1.3.6.1.4.1.1.3
general	1.3.6.1.4.1.1.3.1
proip	1.3.6.1.4.1.1.3.2
defgw	1.3.6.1.4.1.1.3.2.1
IP proProtoIpDefGwAddress	1.3.6.1.4.1.1.3.2.1.1	IpAddress	read-only	The Internet address of the default gateway for the router.
INT proProtoIpDefGwCost	1.3.6.1.4.1.1.3.2.1.2	INTEGER	read-only	The cost of the default gateway for the router.
INT proProtoIpDefGwAge	1.3.6.1.4.1.1.3.2.1.3	INTEGER	read-only	The age of the default gateway for the router.
pDot3ChipSets	1.3.6.1.4.1.1.5
pDot3ChipMC68EN360	1.3.6.1.4.1.1.5.1
ibm	1.3.6.1.4.1.2
ibmProd	1.3.6.1.4.1.2.6
ibm2210	1.3.6.1.4.1.2.6.72
NTF ibmElsTrapV1	1.3.6.1.4.1.2.6.72.0.1			An ELS trap event. Note that this trap is being deprecated and will not be supported in all future releases. The objects proELSTrapVar1 through proElsTrapVar9 are conditionally included in this trap to carry variable data fields from the ELS message. These objects are not carried as object IDs as defined, but in fact are data objects. Their syntax will change depending on the data they cary for a particular trap instance.
NTF ibmElsTrapV2	1.3.6.1.4.1.2.6.72.0.2			When the routing subsystem ELS component is configured to generate SNMP traps, the following trap is generated. It contains a single varBind containing a text string in one of the two following formats. If ELS timestamping is enabled: hr:min:sec subsys_name.event_num: message_text For example - 09:32:56 IP.008: no rte 9.7.1.8 -> 9.7.4.3 dsc If ELS timestamping is disabled: subsys_name.event_num: message_text For example - IP.008: no rte 9.7.1.8 -> 9.7.4.3 dsc
ibm2210admin	1.3.6.1.4.1.2.6.72.1
ibm2210system	1.3.6.1.4.1.2.6.72.2
ibm2210hardware	1.3.6.1.4.1.2.6.72.3
ibm2210hardwareinfo	1.3.6.1.4.1.2.6.72.3.1
ibmServiceGenericTable	1.3.6.1.4.1.2.6.72.3.1.1		not-accessible	A table of information about each service port.
ibmServiceGenericEntry	1.3.6.1.4.1.2.6.72.3.1.1.1		not-accessible	An entry containing objects to describe the service port.
INT ibmServiceGenericPort	1.3.6.1.4.1.2.6.72.3.1.1.1.1	INTEGER	read-only	The number of service port. On 12x and 1Sx/1Ux models, only one service port exists and is designated #1. On x4x models, the lower paort is designated #1, the upper port is #2.
INT ibmServiceGenericBaurdrate	1.3.6.1.4.1.2.6.72.3.1.1.1.2	INTEGER	read-only	The baudrate of service port.
INT ibmServiceGenericType	1.3.6.1.4.1.2.6.72.3.1.1.1.3	INTEGER	read-only	The card type of service port. On 12x, 1Sx and 1Ux models, the second row will always indeicate nocard(3).
ibm2210routing	1.3.6.1.4.1.2.6.72.4
ibm2210switching	1.3.6.1.4.1.2.6.72.5

RFC description

Enterprise MIB for IBM 2210 router family hardware information and system management.

Start monitoring IBM 2210 Nways Multiprotocol Router with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

Download IBM2210-MIB

What Is IBM2210-MIB?

Supported Devices

Monitoring Examples

What Can Be Monitored

This MIB depends on

Related MIBs

RFC description