RUCKUS-SZ-EVENT-MIB

MIB Reference — IPNetwork Monitor · Updated September 09, 2026

All MIBsRUCKUS-SZ-EVENT-MIB

Organization: Ruckus Wireless, Inc.

Last Updated: 2015-08-18

Category: Wireless and Radio

Description: Defines SNMP trap notifications for Ruckus SmartZone controller operational and alarm events.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

What Is RUCKUS-SZ-EVENT-MIB?

RUCKUS-SZ-EVENT-MIB defines SNMP trap notifications for the Ruckus SmartZone wireless LAN controller, covering operational and alarm-level events generated by the controller and its managed access points. Rather than polled counters, its data category is fault/event notification: traps carrying an event OID and payload describing what happened (e.g. AP up/down, alarm raised/cleared) on the SmartZone system. This is fundamentally a fault-monitoring MIB for hardware/software status changes, letting an admin receive near-real-time notifications of controller or AP state transitions rather than having to poll for them. The presence of an object like ruckusPrimaryGRE suggests some events relate to GRE tunnel connectivity between APs and the SmartZone controller. It is deployed in enterprise/carrier Wi-Fi environments where SmartZone controllers forward SNMP traps to a central NMS for real-time alerting, and a RUCKUS-SZ-EVENT-MIB download provides the trap definitions needed to configure that NMS.

IPNetwork Monitor allows you to monitor SNMP objects defined in RUCKUS-SZ-EVENT-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.

Supported Devices

  • Ruckus SmartZone wireless LAN controllers

Monitoring Examples

A monitoring station configured to receive SNMP traps from this MIB would be alerted when a trap fires referencing ruckusPrimaryGRE, indicating a change in the primary GRE tunnel state between an access point and the SmartZone controller (e.g. tunnel down). Because this module is event/trap-oriented rather than a table of pollable counters, an admin's typical workflow is to watch the trap receiver for these notifications rather than periodically polling values. The trap payload would be inspected to identify which AP or controller subsystem generated the alarm and its severity.

What Can Be Monitored

  • GRE tunnel state change events
  • controller/AP alarm notifications
Imported Objects

From RUCKUS-ROOT-MIB

ruckusEventsOBJECT-IDENTITY

From SNMPv2-CONF

MODULE-COMPLIANCE
OBJECT-GROUP

From SNMPv2-SMI

IpAddress
MODULE-IDENTITY
OBJECT-TYPE
Unsigned32
enterprises

From SNMPv2-TC

DisplayString
MacAddress
OIDs

RFC description

Vendor-private Ruckus MIB for SmartZone (SZ) event management; defines objects for Ruckus SmartZone controller events, alarms, and notifications.

Start monitoring Ruckus SmartZone wireless LAN controllers (operational/alarm event trap notifications) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

Download RUCKUS-SZ-EVENT-MIB