Description: Returns or changes the amount of resource saving memory set aside to hold permanent soft PCL resources. Additional information: The value returned by this object is the amount of Resource Saving memory currently dedicated to PCL, regardless of the value of RESOURCE-SAVING. For a PCL-only printer, the value of this object is zero. All memory is dedicated to PCL, but it is not shown as such. If PostScript is installed without a duplex unit, the default value of this object is as follows: Zero if <13M memory is installed. Zero if 13M memory is installed and RESOURCE-SAVING=eOff. 409600 if 13M memory is installed and RESOURCE-SAVING=eOn. 409600 if 13M memory is installed and RESOURCE-SAVING=eAuto; plus 102400 for each 1M over 13M memory installed. If PostScript is installed with a duplex unit, the default value of this object is as follows: Zero if <24M memory is installed. Zero if 24M memory is installed and RESOURCE-SAVING=eOff. 409600 if 24M memory is installed and RESOURCE-SAVING=eOn. 409600 if 24M memory is installed and RESOURCE-SAVING=eAuto; plus 102400 for each 1M over 24M memory installed. If RESOURCE-SAVING=eOn, this object can be used to set the amount of Resource Saving memory currently dedicated to PCL. The values supported are zero (to turn resource saving off for PCL) and 409600 through 409600 plus the value of MAXIMUM-RESOURCE-SAVING-MEMORY, in increments of 102400. If a value is received that is between 1 and 409599, it will be snapped to 409600 and a status of returned. If an unsupported value greater than 409600 is received, it will be snapped down to the nearest 102400 value and a status of returned. Attempting to set this object when RESOURCE-SAVING is eAuto or eOff will cause a status of to be returned.