All MIBs › CXPhysicalInterfaceManager-MIB
Category: Vendor: Memotec
Description: Manages physical interface assignment and layer 1 parameters on CX Memotec devices.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is CXPhysicalInterfaceManager-MIB?
CXPhysicalInterfaceManager-MIB is a vendor-specific MIB attributed to Memotec's CX platform, used to manage physical (Layer 1) interface assignment and parameters on Memotec network access/multiplexer devices. Based on the limited sample objects, it exposes a physical interface table listing interface index and type, i.e. basic inventory/configuration data about the physical ports present on the device. With only cxPhyIfTable/cxPhyIfEntry/cxPhyIfIndex/cxPhyIfType available, this module's monitoring value appears limited to confirming which physical interface types are provisioned on each port rather than reporting rich hardware health telemetry like temperature or power; without further object detail no additional status data can be honestly claimed. As a vendor-specific module it likely parallels or supplements the standard IETF IF-MIB ifTable rather than replacing it. It is typically deployed on Memotec CX-series WAN access/multiplexer equipment in enterprise or carrier network environments. Engineers can download the CXPhysicalInterfaceManager-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in CXPhysicalInterfaceManager-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Memotec CX-series WAN access/multiplexer devices
Monitoring Examples
An administrator would walk cxPhyIfTable, keyed by cxPhyIfIndex, and check cxPhyIfType for each entry to confirm the physical interface type provisioned on a given port matches what was ordered or installed, catching a mismatch (e.g. an interface reporting an unexpected type) during initial device turn-up or after a card swap.
What Can Be Monitored
- physical interface index
- physical interface type
Imported Objects
From CXProduct-SMI
| cxPortManager | OBJECT-IDENTITY |
From RFC-1212
| OBJECT-TYPE |
OIDs
RFC description
Manages physical interface configuration for Connexus network devices, supporting various port types and interface parameters.
Start monitoring Memotec CX-series WAN access/multiplexer device (physical interface inventory) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.