All MIBs › ZTE-AN-REMOTE-UNIT-CHANNEL-MIB
Organization: ZTE Corporation
Last Updated: 2013-05-17
Category: ZTE Access Node (ZTE-AN) Management
Description: Manages ZTE access node remote unit channel configuration for distributed access node architectures.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ZTE-AN-REMOTE-UNIT-CHANNEL-MIB?
This is a ZTE vendor-specific MIB for the Access Node (AN) product line, specifically addressing 'remote units' — subordinate access devices deployed at cabinet or curb locations in a distributed access node architecture, connected back to a central chassis. It exposes channel-level configuration objects describing how communication channels between the central unit and its remote units are set up and identified. Its monitoring relevance is largely operational/configuration status rather than raw performance counters: administrators can verify channel provisioning correctness and, by extension, infer whether a remote unit's uplink channel is configured and expected to be in service, which is a first step in diagnosing connectivity problems to that remote unit. It depends conceptually on the broader ZTE AN remote-unit management framework (including the companion remote-unit file MIB) since channel identity is used elsewhere for correlating file transfers and status. It is typically deployed by telecom operators managing distributed/pizza-box remote access node deployments in FTTx networks, where the ZTE-AN-REMOTE-UNIT-CHANNEL-MIB MIB helps confirm each remote unit's channel is correctly provisioned.
IPNetwork Monitor allows you to monitor SNMP objects defined in ZTE-AN-REMOTE-UNIT-CHANNEL-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- ZTE access node remote unit (distributed cabinet/curb unit)
Monitoring Examples
An operator reviews remote unit channel configuration objects to confirm that the channel linking a newly installed cabinet-mounted remote unit to its parent access node is correctly numbered and enabled. If a remote unit is unreachable, comparing its expected channel configuration against actual state can reveal a provisioning mismatch as the root cause rather than a physical fault. No sample objects were present in the source extract, so exact object names cannot be confirmed here.
What Can Be Monitored
- remote unit channel configuration
- channel identifier/index
- channel enable/disable state
- remote unit-to-host channel mapping
Imported Objects
From IF-MIB
| ifIndex | OBJECT-TYPE |
From SNMPv2-CONF
| MODULE-COMPLIANCE | |
| OBJECT-GROUP |
From SNMPv2-SMI
| Integer32 | |
| MODULE-IDENTITY | |
| OBJECT-TYPE |
From SNMPv2-TC
| RowStatus |
From ZTE-AN-IF-MIB
| zxAnSubIfIndex | OBJECT-TYPE |
From ZTE-AN-SMI
| zxAnSystem | OBJECT-IDENTITY |
OIDs
RFC description
Manages remote unit channel functionality including TCP port allocation and FTP control link aging for ZTE access networks.
Start monitoring ZTE access node remote unit (distributed cabinet/curb unit) (channel-provisioning config status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.