All MIBs › TPLINK-ETHERNETOAMBASICCFG-MIB
Category: Link Layer and Ethernet Protocols
Description: Manages TP-Link switch Ethernet OAM basic per-port configuration including mode and PDU rate.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is TPLINK-ETHERNETOAMBASICCFG-MIB?
TPLINK-ETHERNETOAMBASICCFG-MIB is a private TP-Link enterprise MIB that manages basic Ethernet OAM (Operations, Administration and Maintenance, IEEE 802.3ah) configuration on a per-port basis, covering settings such as OAM mode (active/passive) and PDU (Protocol Data Unit) transmission rate. It exposes configuration-category data used to establish and tune the OAM link-monitoring session between a switch and its link partner. In monitoring terms this MIB is about the software/protocol configuration status of the OAM feature itself -- confirming which ports have OAM enabled, in what mode, and at what PDU rate -- which underpins fault detection on the physical link rather than exposing device-wide hardware health like temperature or power. Ethernet OAM as a protocol is defined by IEEE 802.3, so this MIB's configuration model builds on that standard even though no explicit MIB cross-reference is given. It is deployed on TP-Link managed switches at the network edge, particularly where a service provider or enterprise wants standardized link-level OAM monitoring toward a demarcation point, making TPLINK-ETHERNETOAMBASICCFG-MIB SNMP monitoring a routine part of validating those OAM sessions.
IPNetwork Monitor allows you to monitor SNMP objects defined in TPLINK-ETHERNETOAMBASICCFG-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- TP-Link managed Ethernet switch
Monitoring Examples
No sample object names were provided, but consistent with the module's purpose an admin would poll a per-port OAM configuration table to confirm OAM mode (active vs. passive) and PDU transmission interval are set as expected on WAN-facing or provider-facing ports, since a port left in the wrong mode would fail to establish an OAM discovery session with its peer.
What Can Be Monitored
- Ethernet OAM enable/mode per port
- OAM PDU transmission rate
- OAM configuration consistency across ports
Imported Objects
From RFC1213-MIB
| ifIndex |
From SNMPv2-SMI
| OBJECT-TYPE |
From SNMPv2-TC
| DisplayString |
| ethernetOamBasicConfig | OBJECT-IDENTITY |
OIDs
RFC description
Configures Ethernet OAM (Operations, Administration, Maintenance) parameters for Layer 2 network monitoring and troubleshooting.
Start monitoring TP-Link managed Ethernet switch (per-port OAM mode/PDU-rate config status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.