Select a Nokia/Alcatel-Lucent 7750 SR, 7705 SAR packet-transport router (MPLS-TP admin state/OAM template status) as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and type vRtrMplsTpLspPtPathMepWTRTimer into the Find box to locate it in the OID tree, selecting the specific row/instance you want to monitor since this is a table column, then select it and click OK. The value of vRtrMplsTpLspPtPathMepWTRTimer indicates the remaining Wait-To-Restore time, in seconds, before the protection path can switch back to the working path. On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is a Counter32-type OID, Value bounds is the most useful condition here — trigger an alert if the value stays unexpectedly high or low relative to what you'd expect for this timer, since that can indicate a stuck or stale state. Click Finish to create the monitor; you can adjust any parameter later.