| OID symbolic | OID numeric | Type | Access | Description |
|---|
| rsIpPolicyMIB | 1.3.6.1.4.1.2773.2.13 | | | The IP Policy MIB for the
Redstone Communications Inc. enterprise. |
| rsIpPolicyObjects | 1.3.6.1.4.1.2773.2.13.1 | | | |
| rsIpAccessList | 1.3.6.1.4.1.2773.2.13.1.1 | | | |
| rsIpAccessListTable | 1.3.6.1.4.1.2773.2.13.1.1.1 | | not-accessible | This table contains entries for elements of IP access lists.
Entries belonging to the same access list are ordered, and
comparisons to those entries are performed in that order until
a match is detected. If no match is found, the default action
is to 'deny'. |
| rsIpAccessListEntry | 1.3.6.1.4.1.2773.2.13.1.1.1.1 | | not-accessible | Each entry describes the characteristics of an IP access list element. |
| I32 rsIpAccessListId | 1.3.6.1.4.1.2773.2.13.1.1.1.1.1 | Integer32 | not-accessible | The number of the access list to which this entry belongs. |
| I32 rsIpAccessListElemId | 1.3.6.1.4.1.2773.2.13.1.1.1.1.2 | Integer32 | not-accessible | The relative position of this entry within its access list.
Access list entries are searched in this sequence (low to
high values) until a match is found.
NOTE:
The value zero is reserved for use with SET operations
to perform special-purpose table entry creations/deletions;
see the DESCRIPTION of rsIpAccessListRowStatus for details.
Get/GetNext/GetBulk retrievals never return an entry for which
this object is zero-valued. |
| ROW rsIpAccessListRowStatus | 1.3.6.1.4.1.2773.2.13.1.1.1.1.3 | RowStatus | read-create | Controls creation/deletion of entries in this table
according to the RowStatus textual convention,
constrained to support the following values only:
createAndGo
destroy
Two configuration levels are defined, limited and full.
EARLY IMPLEMENTATIONS MIGHT PROVIDE ONLY THE LIMITED LEVEL
OF CONFIGURATION CAPABILITY.
*** LIMITED ACCESS LIST CONFIGURATION LEVEL ***
1) RowStatus createAndGo/destroy operations directed to a
target table entry for which rsIpAccessListElemId is ZERO,
have the following special-purpose semantics:
createAndGo Create an entry having the specified
configuration and append it to the
target list, i.e. assign it a value
of rsIpAccessListElemId that is one
greater than the current last element
in the list.
destroy Destroy the specified list and all of
its constituent elements.
2) RowStatus createAndGo/destroy operations directed to a
target table entry for which rsIpAccessListElemId is NONZERO
are disallowed.
*** FULL ACCESS LIST CONFIGURATION LEVEL ***
Permit conventional RowStatus-based management of table
entries having a nonzero value for rsIpAccessListElemId,
IN ADDITION TO the special RowStatus semantics applied
to entries having a zero value for rsIpAccessListElemId.
To create an entry in this table, the following
entry objects MUST be explicitly configured:
rsIpAccessListRowStatus
In addition, when creating an entry the following
conditions must hold:
The value of rsIpAccessListElemId is nonzero.
Once created, element attributes cannot be modified
except by a RowStatus destroy operation to delete the
list element. |
| INT rsIpAccessListAction | 1.3.6.1.4.1.2773.2.13.1.1.1.1.4 | INTEGER | read-create | Specifies the disposition of an item that matches the comparison
criteria described by this entry. |
| IP rsIpAccessListSrc | 1.3.6.1.4.1.2773.2.13.1.1.1.1.5 | IpAddress | read-create | A source IP address. A subject IP address is first masked with the
value of rsIpAccessListSrcMask, then the result is compared to this value.
Setting both this object and its corresponding mask to 0.0.0.0 acts as
a wildcard, matching any source IP address. |
| IP rsIpAccessListSrcMask | 1.3.6.1.4.1.2773.2.13.1.1.1.1.6 | IpAddress | read-create | The IP address mask to be applied to a subject source IP address before
comparing it to rsIpAccessListSrc. Ones in the mask identify which bits
in the subject IP address are significant for the comparison.
To be considered valid, a nonzero value for this object must contain a
single contiguous string of ones, beginning with the most significant bit
of the mask. |
| IP rsIpAccessListDst | 1.3.6.1.4.1.2773.2.13.1.1.1.1.7 | IpAddress | read-create | A destination IP address. A subject IP address is first masked with the
value of rsIpAccessListDstMask, then the result is compared to this value.
Setting both this object and its corresponding mask to 0.0.0.0 acts as
a wildcard, matching any destination IP address. |
| IP rsIpAccessListDstMask | 1.3.6.1.4.1.2773.2.13.1.1.1.1.8 | IpAddress | read-create | The IP address mask to be applied to a subject destination IP address before
comparing it to rsIpAccessListDst. Ones in the mask identify which bits
in the IP address are significant for the comparison.
To be considered valid, a nonzero value for this object must contain a
single contiguous string of ones, beginning with the most significant bit
of the mask. |
| I32 rsIpAccessListProtocol | 1.3.6.1.4.1.2773.2.13.1.1.1.1.9 | Integer32 | read-create | An IP Protocol value. Nonzero values match a specific IP Protocol value
(e.g. 6 for TCP) carried in an IP packet; a value of zero acts as a wildcard,
matching any IP Protocol. |
| rsIpPolicyConformance | 1.3.6.1.4.1.2773.2.13.4 | | | |
| rsIpPolicyCompliances | 1.3.6.1.4.1.2773.2.13.4.1 | | | |
| rsIpPolicyCompliance | 1.3.6.1.4.1.2773.2.13.4.1.1 | | | The compliance statement for entities which implement
the Redstone IP Policy MIB. |
| rsIpPolicyGroups | 1.3.6.1.4.1.2773.2.13.4.2 | | | |
| rsIpAccessListGroup | 1.3.6.1.4.1.2773.2.13.4.2.1 | | | A collection of objects for managing IP access list
capabilities in a Redstone product. |
