Description: Setting this value to `powerCycleReset', `resetToNVRAM', or `resetToFactoryDefaults' will result in the resetting of the printer. When read, this object will always have the value `notResetting(3)', and a SET of the value `notResetting' shall have no effect on the printer. Some of the defined values are optional. However, every implementation must support at least the values `notResetting' and resetToNVRAM'. Additional information: All resets follow the same sequence of events except that a a value of ePresetToFactoryDefaults first makes a call to reset the NVRAM to factory defaults. Then, the following sequence of events occur: 1. A 1 second delay is initiated while a reply is returned to the requestor indicating OK. The printer waits for the second to elapse. 2. The printer goes off-line. 3. The control panel is disabled. 4. The paper path is flushed. 5. The printer is reset per the request. The printer will respond to PML requests up to this point in time.

Setting this object to ePpowerCycleReset causes LaserJet 5Si to perform its power on initialization routines. I/O cards are reset (NVRAM on the cards is not changed; all I/O buffers are flushed). The tests normally run at power on time are executed.

Setting this object to ePresetToNVRAM causes the printer to reset itself to its power on state without doing its normal power on testing. The I/O cards are not reset and I/O buffers remain intact.

Setting this object to ePresetToFactoryDefaults causes the same action as a Cold Reset operation performed at the control panel (except power on testing is not performed). The I/O cards are not reset and I/O buffers remain intact.