All MIBs › Juniper-OSPF-CONF
Organization: Juniper Networks, Inc.
Last Updated: 2002-09-06
Category: Protocol: OSPF, Vendor: Juniper
Description: Juniper Networks OSPF protocol conformance and compliance statements MIB for Juniper E-series edge routers.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is Juniper-OSPF-CONF?
Juniper-OSPF-CONF is an AGENT-CAPABILITIES module declaring which OSPF-related MIBs and object groups the JUNOSe SNMP agent supports on Juniper's E-series edge routers, rather than defining OSPF data objects itself. It defines two capability statements: the obsolete juniOspfAgentV1, covering JUNOSe 2.x/3.x support for OSPF-MIB, OSPF-TRAP-MIB, and the vendor Juniper-OSPF-MIB (including groups like ospfBasicGroup, ospfAreaGroup, juniOspfBasicGroup), and the current juniOspfAgentV2, covering JUNOSe 4.0 and later with an expanded juniOspfBasicGroup2. Both statements mark ospfConfigErrorType, ospfPacketType, and ospfPacketSrc as accessible only within notifications, clarifying that these OSPF-MIB objects appear in traps rather than being directly pollable. It depends on OSPF-MIB, OSPF-TRAP-MIB, and Juniper-OSPF-MIB for the actual OSPF protocol state it describes support for, and it is deployed on Juniper E-series edge routers running JUNOSe, where operators reference the Juniper-OSPF-CONF MIB to confirm which OSPF object groups a given JUNOSe release exposes via SNMP.
IPNetwork Monitor allows you to monitor SNMP objects defined in Juniper-OSPF-CONF. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Juniper Networks E-series edge routers running JUNOSe
Monitoring Examples
An operator checks whether a JUNOSe 4.0 router reports juniOspfAgentV2 to confirm juniOspfBasicGroup2 and juniOspfNbrGroup are supported before building OSPF neighbor-state dashboards; a router still reporting the obsolete juniOspfAgentV1 would indicate an older JUNOSe release with a smaller supported OSPF object set.
What Can Be Monitored
- agent capability/object-group support per JUNOSe release
- OSPF-MIB conformance group coverage
- Juniper-OSPF-MIB vendor object group coverage
- notification-only object variations
Imported Objects
From Juniper-Agents
| juniAgents | MODULE-IDENTITY |
From SNMPv2-CONF
| AGENT-CAPABILITIES |
From SNMPv2-SMI
| MODULE-IDENTITY |
OIDs
RFC description
Juniper vendor-private MIB for OSPF (Open Shortest Path First) routing protocol configuration and management on Juniper routers.
Start monitoring Juniper Networks E-series edge router running JUNOSe (agent capabilities, OSPF) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.