INFOSIM-TRAPMIB

Description: InfoSim StableNet network management trap MIB defining SNMP notifications for fault and event reporting.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

INFOSIM-TRAPMIB is a vendor-specific MIB from InfoSim, defining SNMP notifications used by the StableNet network management platform to report faults and events it has detected. It exposes an agent event table carrying the monitored target's name and IP address, the current event state, alarm timestamp, severity/alarm level, and a free-text alarm description. Rather than exposing raw hardware sensors, this MIB is itself part of the monitoring layer: it carries fault/event status about other devices' hardware or software health as detected and classified by StableNet's monitors, essentially forwarding alarm state upstream. It relies on standard SNMP trap/notification conventions rather than any specific hardware MIB, since it is a meta-monitoring/event-forwarding module. It is deployed as part of an InfoSim StableNet NMS installation, where INFOSIM-TRAPMIB SNMP monitoring forwards correlated fault events to upstream dashboards or trap receivers.

An upstream trap receiver correlates snAgentEventTable/snAgentEventEntry by snAgentEventIndex, reading snMonitorName and snMonitorIP to identify which monitored target raised the alert. snEventState and snEventStateString together with snSeverityLevel/snAlarmLevel gauge how serious the condition is, while snAlarmTime and snAlarmDescription give the timestamp and human-readable text of a StableNet-detected fault, such as a monitor transitioning into a critical state.

Infosim SNMPv1 trap events MIB for monitoring system alarms and event notifications.