All MIBs › HP-ICF-LAYER3VLAN-MIB
Organization: HP Networking
Last Updated: 2010-03-23
Category: Technology: Routing/L3, Technology: VLAN, VLAN and Bridging, Vendor: HP/HPE
Description: HP ICF SNMP MIB for Layer 3 VLAN interface configuration including IP addresses and routing on HP ProCurve switches.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is HP-ICF-LAYER3VLAN-MIB?
HP-ICF-LAYER3VLAN-MIB is part of HP's Integrated Communication Facility (ICF) MIB family, used on HP ProCurve (now Aruba/HPE Networking) switches to manage Layer 3 VLAN interfaces, including enabling/disabling routing and associated IP addressing on a per-VLAN basis. It is primarily a configuration-oriented MIB describing which VLANs have Layer 3 routing enabled and their associated interface parameters rather than a rich runtime-statistics MIB. Its monitoring value lies in confirming Layer 3 routing configuration state per VLAN, which is a software-configuration health check rather than classic hardware metrics like temperature or CPU, though a misconfigured or unexpectedly disabled Layer 3 VLAN would explain routing failures on a switch. It works alongside the standard IF-MIB and VLAN-related MIBs (e.g. Q-BRIDGE-MIB) that provide the underlying VLAN and interface index context. It is deployed on HP ProCurve/Aruba switches performing inter-VLAN routing in enterprise campus networks. Engineers can download the HP-ICF-LAYER3VLAN-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in HP-ICF-LAYER3VLAN-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- HP ProCurve/Aruba switch (ICF product line)
Monitoring Examples
No object names were captured in this extract, but consistent with its purpose an administrator would typically check a per-VLAN table for the Layer 3 enable/disable flag and associated IP address to confirm routing is active on the expected VLANs, flagging any VLAN where Layer 3 routing was unexpectedly disabled. Because sample_objects is empty, specific table/column names cannot be confirmed from this extract.
What Can Be Monitored
- Layer 3 VLAN routing enable/disable state
- VLAN IP address configuration
Imported Objects
From HP-ICF-OID
| hpSwitch | OBJECT-IDENTITY |
From IF-MIB
| ifIndex | OBJECT-TYPE |
From SNMPv2-CONF
| MODULE-COMPLIANCE | |
| OBJECT-GROUP |
From SNMPv2-SMI
| MODULE-IDENTITY | |
| OBJECT-TYPE |
OIDs
RFC description
Configures Layer 3 (IPv4/IPv6) routing on VLAN interfaces for HP Integrated Communication Facility devices.
Start monitoring HP ProCurve/Aruba switch (Layer 3 VLAN interface enable/config) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.