| OID symbolic | OID numeric | Type | Access | Description |
|---|
| NTF ciscoPimInterfaceDown | 1.3.6.1.4.1.9.9.184.2.0.2 | | | A ciscoPimInterfaceDown notification signifies the loss
of a PIM interface. This notification should be generated
whenever an entry is about to be deleted from the
PimInterfaceTable.
pimInterfaceStatus identifies the interface which
was involved in the generation of this notification. |
| NTF ciscoPimInterfaceUp | 1.3.6.1.4.1.9.9.184.2.0.1 | | | A ciscoPimInterfaceUp notification signifies the
restoration of a PIM interface. This notification
should be generated whenever pimInterfaceStatus
transitions into the 'active' state.
pimInterfaceStatus identifies the interface which
was involved in the generation of this notification. |
| NTF ciscoPimInvalidJoinPrune | 1.3.6.1.4.1.9.9.184.2.0.5 | | | A ciscoPimInvalidJoinPrune notification signifies the
receipt of an invalid join/prune message.
This notification is generated whenever the
cpimInvalidJoinPruneMsgsRcvd counter is incremented.
cpimLastErrorOrigin, cpimLastErrorGroup, and
cpimLastErrorRP should signify the source address, group
address and the RP address in the invalid join/prune
packet. |
| NTF ciscoPimInvalidRegister | 1.3.6.1.4.1.9.9.184.2.0.4 | | | A ciscoPimInvalidRegister notification signifies that
an invalid Register message was received by this device.
This notification is generated whenever the
cpimInvalidRegisterMsgsRcvd counter is incremented.
cpimLastErrorOrigin, cpimLastErrorGroup, and
cpimLastErrorRP should signify the source address, group
address and the RP address in the invalid register
packet. |
| ciscoPimMIB | 1.3.6.1.4.1.9.9.184 | | | This MIB module defines the cisco specific variables
for Protocol Independent Multicast (PIM) management.
These definitions are an extension of those defined in
the IETF PIM MIB (RFC 2934). |
| ciscoPimMIBCompliances | 1.3.6.1.4.1.9.9.184.3.1 | | | |
| ciscoPimMIBConformance | 1.3.6.1.4.1.9.9.184.3 | | | |
| ciscoPimMIBGroups | 1.3.6.1.4.1.9.9.184.3.2 | | | |
| ciscoPimMIBNotificationObjects | 1.3.6.1.4.1.9.9.184.2.1 | | | |
| ciscoPimMIBNotificationPrefix | 1.3.6.1.4.1.9.9.184.2 | | | |
| ciscoPimMIBNotifications | 1.3.6.1.4.1.9.9.184.2.0 | | | |
| ciscoPimMIBObjects | 1.3.6.1.4.1.9.9.184.1 | | | |
| ciscoPimNotificationObjectGroup | 1.3.6.1.4.1.9.9.184.3.2.2 | | | A collection of objects that are supported only for
notification purpose. |
| NTF ciscoPimRPMappingChange | 1.3.6.1.4.1.9.9.184.2.0.3 | | | A ciscoPimRPMappingChange notification signifies a change
in the RP Mapping on the device in question. A change in RP
Mapping could be because of addition of new entries to the
RP Mapping cache, deletion of existing entries, or a
modification to an existing mapping. The type of change is
indicated by cpimRPMappingChangeType. pimRPSetHoldTime
is used to identify the row in the pimRPSetTable that is
responsible for the generation of this notification.
In case of modification to existing entries, a
notification should be generated once before the
modification (with cpimRPMappingChangeType set to
modifiedOldMapping) and once after modification (with
cpimRPMappingChangeType set to modifiedNewMapping).
NOTE: A high frequency of RP Mapping change could result
in a large number of ciscoPimRPMappingChange notifications
being generated. Hence, in environments where the
possibility of a high frequency of RP Mapping change
exists, enable this notification with utmost care. |
| ciscoPimSparseMIBCompliance | 1.3.6.1.4.1.9.9.184.3.1.1 | | | The compliance statement for devices running PIM Sparse
Mode and implementing the CISCO PIM MIB. |
| ciscoPimSparseMIBGroup | 1.3.6.1.4.1.9.9.184.3.2.1 | | | A collection of objects to support management of PIM
Sparse mode on Cisco devices. |
| cpim | 1.3.6.1.4.1.9.9.184.1.1 | | | |
| C32 cpimInvalidJoinPruneMsgsRcvd | 1.3.6.1.4.1.9.9.184.1.1.2 | Counter32 | read-only | A count of the number of invalid PIM Join/Prune
messages received by this device. A PIM Join/Prune
message is termed invalid if
o the RP specified in the packet is not the RP for
the group in question. |
| C32 cpimInvalidRegisterMsgsRcvdEx | 1.3.6.1.4.1.9.9.184.1.1.1 | Counter32 | read-only | A count of the number of invalid PIM Register messages
received by this device. A PIM Register message is
termed invalid if
o the encapsulated IP header is malformed,
o the destination of the PIM Register message is not the
RP (Rendezvous Point) for the group in question,
o the source/DR (Designated Router) address is not a valid
unicast address. |
| IP cpimLastErrorGroup | 1.3.6.1.4.1.9.9.184.1.1.7 | InetAddress | read-only | The IP multicast group address to which the last invalid
packet was addressed. The type of address stored
depends on the value in cpimLastErrorGroupType.
The value of this object is a zero-length InetAddress if
there is a problem in the packet received from the DR,
for eg. a malformed encapsulated IP header.
The value of this object is irrelevant if the value of
cpimLastErrorType is none(1). |
| IPt cpimLastErrorGroupType | 1.3.6.1.4.1.9.9.184.1.1.6 | InetAddressType | read-only | Represents the type of address stored in
cpimLastErrorGroup. The value of this object is unknown(0)
if there is a problem in the packet received from the
DR.
The value of this object is irrelevant if the value of
cpimLastErrorType is none(1). |
| IP cpimLastErrorOrigin | 1.3.6.1.4.1.9.9.184.1.1.5 | InetAddress | read-only | This object represents the Network Layer Address of the
source that originated the last invalid packet. The type
of address stored depends on the value in
cpimLastErrorOriginType.
The value of this object represents the Network Layer
Address of the Designated Router (DR) whenever the value
of cpimLastErrorGroup is a zero-length address,
for eg. when encapsulated IP header is malformed.
The value of this object is irrelevant if the value of
cpimLastErrorType is none(1). |
| IPt cpimLastErrorOriginType | 1.3.6.1.4.1.9.9.184.1.1.4 | InetAddressType | read-only | Represents the type of address stored in
cpimLastErrorOrigin. The value of this object is
irrelevant if the value of cpimLastErrorType is none(1). |
| IP cpimLastErrorRP | 1.3.6.1.4.1.9.9.184.1.1.9 | InetAddress | read-only | The address of the RP, as per the last invalid
packet. The type of address stored depends on the value in
cpimLastErrorRPType.
The value of this object is irrelevant if the value of
cpimLastErrorType is none(1). |
| IPt cpimLastErrorRPType | 1.3.6.1.4.1.9.9.184.1.1.8 | InetAddressType | read-only | Represents the type of address stored in
cpimLastErrorRP. The value of this object is irrelevant
if the value of cpimLastErrorType is none(1). |
| INT cpimLastErrorType | 1.3.6.1.4.1.9.9.184.1.1.3 | INTEGER | read-only | The type of the last invalid message that was received by
this device. |
| INT cpimRPMappingChangeType | 1.3.6.1.4.1.9.9.184.2.1.1 | INTEGER | read-only | Describes the operation that resulted in generation
of cpimRPMappingChange notification.
o newMapping, as the name suggests indicates that a new
mapping has been added into the pimRPSetTable,
o deletedMapping indicates that a mapping has been
deleted from the pimRPSetTable, and,
o modifiedXXXMapping indicates that an RP mapping (which
already existed in the table) has been modified.
The two modifications types i.e. modifiedOldMapping
and modifiedNewMapping, are defined to differentiate
the notification generated before modification from
that generated after modification. |
