3 modules from Eaton
Eaton's MIBs in this database cover data-center power-protection hardware -- rack power distribution units (ePDU, in managed, metered-input, and switched-outlet variants), automatic transfer switches, environmental monitoring probes, and the Power Xpert Gateway card that brings UPS/PDU alarms onto the network -- rather than any networking equipment. Recurring subject matter is electrical and environmental health: input current/voltage/power-factor and ground-current readings per PDU phase or panel, transfer-switch input-source and dephasing status, temperature/humidity and dry-contact sensor readings, and an active-alarm/event log surfacing conditions like UPS-on-battery or overload. If you manage Eaton (or Powerware/Exide-lineage) UPS, PDU, or ATS hardware in a data center or telecom facility, look here for the vendor-specific power and environmental OIDs, which commonly run alongside the standard UPS-MIB (RFC 1628) on the same device. Eaton's module names generally carry an EATON- prefix tied to the specific product (ATS2, EPDU, EMP, PXG), rooted under the shared EATON-OIDS/xups OID tree, so match the exact module to your specific PDU or UPS variant rather than assuming shared object definitions across the family.
| Module | Description |
|---|---|
| EATON-EMP-MIB | Eaton Environmental Monitoring Probe MIB for monitoring temperature, humidity, and contact inputs on Eaton power equipment. |
| EATON-EPDU-MA-MIB | Eaton ePDU Managed/Advanced MIB for monitoring and controlling intelligent rack power distribution unit outlets and measurements. |
| EATON-OIDS | Eaton OID registration MIB defining the top-level enterprise OID hierarchy for Eaton power management products. |