| OID symbolic | OID numeric | Type | Access | Description |
|---|
| zxr10ProtocolRoutesMIB | 1.3.6.1.4.1.3902.3.6000.160 | | | ZXROSNG PROTOCOL ROUTES MIB |
| zxr10ProtocolRoutesGlobalObjects | 1.3.6.1.4.1.3902.3.6000.160.1 | | | |
| zxr10ProtocolRoutesObjects | 1.3.6.1.4.1.3902.3.6000.160.2 | | | |
| zxr10ProtocolRoutesIPv4Objects | 1.3.6.1.4.1.3902.3.6000.160.2.1 | | | |
| zxr10prIPv4GlobalObjects | 1.3.6.1.4.1.3902.3.6000.160.2.1.1 | | | |
| zxr10prIPv4GlobalMaxRoutes | 1.3.6.1.4.1.3902.3.6000.160.2.1.1.1 | | | |
| U32 zxr10prIPv4gmrRouteNum | 1.3.6.1.4.1.3902.3.6000.160.2.1.1.1.1 | Unsigned32 | read-write | the max-route num which means the maximum of
the global route table.If this attribute is not set,
its value should be set to 0.This attibute
must set with zxr10VrfRouteWarningPercent together.
If you just set this attibute only,there will
be an error! |
| U32 zxr10prIPv4gmrWarningPercent | 1.3.6.1.4.1.3902.3.6000.160.2.1.1.1.2 | Unsigned32 | read-write | when the routes in the global route table exceeded
the warningpercent there will be a alarm displayed
in the interface.If this attribute is not set,
its value should be set to 0.This attibute must
set with zxr10VrfRouteMaxNum together.If you just
set this attibute only, there will be an error! |
| U32 zxr10prIPv4GlobalTableCap | 1.3.6.1.4.1.3902.3.6000.160.2.1.1.2 | Unsigned32 | read-only | the max capability of IPv4 protocol route table |
| zxr10prIPv4VrfRouteTable | 1.3.6.1.4.1.3902.3.6000.160.2.1.2 | | not-accessible | Show the vrf route detail information |
| zxr10prIPv4VrfRouteEntry | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1 | | not-accessible | Show the vrf route detail information |
| STR zxr10prIPv4VrfRouteVrfName | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.1 | DisplayString | not-accessible | VRF Name |
| IP zxr10prIPv4VrfRouteDest | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.2 | IpAddress | not-accessible | The destination IP address of this route. An
entry with a value of 0.0.0.0 is considered a
default route. Multiple routes to a single
destination can appear in the table, but MAX-ACCESS to
such multiple entries is dependent on the table-
MAX-ACCESS mechanisms defined by the network
management protocol in use. |
| INT zxr10prIPv4VrfRouteIfIndex | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.3 | INTEGER | read-only | The IfIndex which uniquely identifies the
local interface through which the next hop of this
route should be reached.If there is no inteface, this
value will be set 0 |
| STR zxr10prIPv4VrfRouteIfName | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.4 | DisplayString | read-only | The IfName which uniquely identifies the
local interface through which the next hop of this
route should be reached.If there is no inteface, this
value will be set NULL |
| INT zxr10prIPv4VrfRouteMetric | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.5 | INTEGER | read-only | The primary routing metric for this route. The
semantics of this metric are determined by the
routing-protocol specified in the route's
zxr10VrfRouteProto value. If this metric is not used,
its value should be set to -1. |
| INT zxr10prIPv4VrfRoutePrf | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.6 | INTEGER | read-only | An alternate routing Preference for this route. The
semantics of this metric are determined by the
routing-protocol specified in the route's
zxr10VrfRouteProto value. If the Preference is not used,
its value should be set to -1. |
| IP zxr10prIPv4VrfRouteNextHop | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.7 | IpAddress | read-only | The IP address of the next hop of this route.
(In the case of a route bound to an interface
which is realized via a broadcast media, the value
of this field is the agent's IP address on that
interface.) |
| INT zxr10prIPv4VrfRouteType | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.8 | INTEGER | read-only | The type of route. Note that the values
direct(3) and indirect(4) refer to the notion of
direct and indirect routing in the IP
architecture.
Setting this object to the value invalid(2) has
the effect of invalidating the corresponding entry
in the zxr10VrfRouteTable object. That is, it
effectively dissasociates the destination
identified with said entry from the route
identified with said entry. It is an
implementation-specific matter as to whether the
agent removes an invalidated entry from the table.
Accordingly, management stations must be prepared
to receive tabular information from agents that
corresponds to entries not currently in use.
Proper interpretation of such entries requires
examination of the relevant zxr10VrfRouteType object. |
| INT zxr10prIPv4VrfRouteProto | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.9 | INTEGER | read-only | The routing mechanism via which this route was
learned. Inclusion of values for gateway routing
protocols is not intended to imply that hosts
should support those protocols. |
| INT zxr10prIPv4VrfRouteAge | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.10 | INTEGER | read-only | The number of seconds since this route was last
updated or otherwise determined to be correct.
Note that no semantics of `too old' can be implied
except through knowledge of the routing protocol
by which the route was learned. |
| IP zxr10prIPv4VrfRouteMask | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.11 | IpAddress | read-only | Indicate the mask to be logical-ANDed with the
destination address before being compared to the
value in the zxr10VrfRouteDest field. For those systems
that do not support arbitrary subnet masks, an
agent constructs the value of the zxr10VrfRouteMask by
determining whether the value of the correspondent
zxr10VrfRouteDest field belong to a class-A, B, or C
network, and then using one of:
mask network
255.0.0.0 class-A
255.255.0.0 class-B
255.255.255.0 class-C
If the value of the zxr10VrfRouteDest is 0.0.0.0 (a
default route), then the mask value is also
0.0.0.0. It should be noted that all IP routing
subsystems implicitly use this mechanism. |
| OID zxr10prIPv4VrfRouteInfo | 1.3.6.1.4.1.3902.3.6000.160.2.1.2.1.12 | OBJECT IDENTIFIER | read-only | A reference to MIB definitions specific to the
particular routing protocol which is responsible
for this route, as determined by the value
specified in the route's zxr10VrfRouteProto value. If
this information is not present, its value should
be set to the OBJECT IDENTIFIER { 0 0 }, which is
a syntatically valid object identifier, and any
conformant implementation of ASN.1 and BER must be
able to generate and recognize this value. |
| zxr10ProtocolRoutesIPv6Objects | 1.3.6.1.4.1.3902.3.6000.160.2.2 | | | |
| zxr10prIPv6GlobalObjects | 1.3.6.1.4.1.3902.3.6000.160.2.2.1 | | | |
| zxr10prIPv6VrfRoutesSumTable | 1.3.6.1.4.1.3902.3.6000.160.2.2.2 | | not-accessible | Show the routes number in this vrf |
| zxr10prIPv6VrfRoutesSumEntry | 1.3.6.1.4.1.3902.3.6000.160.2.2.2.1 | | not-accessible | Show the vrf route detail information |
| STR zxr10prIPv6vrsVrfName | 1.3.6.1.4.1.3902.3.6000.160.2.2.2.1.1 | DisplayString | not-accessible | VRF Name. If this attribute has NULL value, it means that this
is the global table. |
| U32 zxr10prIPv6vrsTotal | 1.3.6.1.4.1.3902.3.6000.160.2.2.2.1.2 | Unsigned32 | read-only | The Total routes number in this ipv6 table. |
| U32 zxr10prIPv6vrsConnect | 1.3.6.1.4.1.3902.3.6000.160.2.2.2.1.3 | Unsigned32 | read-only | The connect routes number in this ipv6 table. |
| U32 zxr10prIPv6vrsRip | 1.3.6.1.4.1.3902.3.6000.160.2.2.2.1.5 | Unsigned32 | read-only | The rip routes number in this ipv6 table. |
| U32 zxr10prIPv6vrsOspf | 1.3.6.1.4.1.3902.3.6000.160.2.2.2.1.6 | Unsigned32 | read-only | The ospf routes number in this ipv6 table. |
| U32 zxr10prIPv6vrsIsis | 1.3.6.1.4.1.3902.3.6000.160.2.2.2.1.7 | Unsigned32 | read-only | The isis routes number in this ipv6 table. |
| U32 zxr10prIPv6vrsBgp | 1.3.6.1.4.1.3902.3.6000.160.2.2.2.1.8 | Unsigned32 | read-only | The bgp routes number in this ipv6 table. |
| zxr10ProtocolRoutesGlobalTraps | 1.3.6.1.4.1.3902.3.6000.160.3 | | | |
| zxr10ProtocolRoutesConformance | 1.3.6.1.4.1.3902.3.6000.160.4 | | | |
