All MIBs › ZXR10-OPTICAL-ALARM-MIB
Organization: ZTE
Last Updated: 2008-04-18
Category: ZTE ZXR10 Interface and Statistics
Description: Monitors ZTE ZXR10 optical interface alarms including loss of signal, power levels, and optical module faults.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ZXR10-OPTICAL-ALARM-MIB?
ZXR10-OPTICAL-ALARM-MIB is a ZTE vendor MIB for the ZXR10 series of carrier switches/routers, focused on optical transceiver and interface alarm monitoring. It exposes fault and alarm data for optical modules, including loss-of-signal conditions, optical power levels (transmit/receive), and general optical module fault states. This is squarely a hardware-health and fault-monitoring MIB: it lets operators detect degraded or failed optical links, out-of-range laser power, and module faults before they cause a full outage. It likely complements the standard IF-MIB (ifTable/ifXTable) for basic interface counters, adding ZTE-specific optical diagnostics on top. It is deployed on ZXR10 carrier-grade switches and routers in metro and core network links using pluggable optical transceivers (SFP/SFP+/XFP). Network engineers evaluating or troubleshooting this functionality can download the ZXR10-OPTICAL-ALARM-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in ZXR10-OPTICAL-ALARM-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- ZTE ZXR10 switch/router
Monitoring Examples
Because sample_objects is empty for this entry, specific object names cannot be confirmed, but a realistic scenario is polling per-port optical alarm status and transmit/receive power level objects to detect a transceiver whose receive power has dropped below threshold, signaling a dirty connector, degrading fiber, or failing laser. Loss-of-signal alarm objects would flag a fully down optical link, letting NOC staff distinguish a fiber cut from a configuration issue.
What Can Be Monitored
- optical loss-of-signal alarm state
- transmit optical power level
- receive optical power level
- optical module fault status
Imported Objects
From SNMPv2-SMI
| MODULE-IDENTITY | |
| NOTIFICATION-TYPE | |
| OBJECT-TYPE | |
| Unsigned32 |
From SNMPv2-TC
| DisplayString | |
| TEXTUAL-CONVENTION |
From ZXR10-SMI
| zxr10 | OBJECT-IDENTITY |
OIDs
RFC description
Monitors optical alarm conditions on ZTE equipment including temperature, voltage, current, and optical power thresholds with severity classification.
Start monitoring ZTE ZXR10 switch/router (optical transceiver loss-of-signal/power-level alarm status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.