ZXR10-OAM-MIB

Description: Defines ZTE ZXR10 Ethernet OAM (IEEE 802.3ah) link monitoring, fault management, and remote loopback.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

ZXR10-OAM-MIB is a vendor MIB from ZTE for its ZXR10 switch platform, covering Ethernet OAM (Operations, Administration, and Maintenance) functionality per IEEE 802.3ah, including link monitoring, fault management/signaling, and remote loopback control on point-to-point Ethernet links. It exposes link-fault and OAM session data: discovery/negotiation state of the OAM protocol on a link, fault indications signaled by the remote peer, and remote loopback control/status, rather than general chassis hardware sensors. In monitoring terms this is a faults/link-health module: it lets an administrator detect degraded or failed Ethernet links at the physical/data-link layer (critical fault, dying gasp, link fault events) and verify or trigger remote loopback testing to isolate a fault, though it does not report CPU, memory, or environmental sensor data. It directly implements the IEEE 802.3ah Ethernet OAM standard and depends on IF-MIB for interface association. It is typically deployed on ZTE ZXR10 switches at the edge of access or metro Ethernet networks where link-level OAM is used to monitor and troubleshoot subscriber or trunk links. Engineers can download the ZXR10-OAM-MIB file directly to load it into their MIB browser.

No sample objects were provided for this module beyond an IMPORTS placeholder, so no concrete object or table names can be cited with confidence. In practice an operator would poll per-link OAM discovery and fault-signal state to detect a remote 'dying gasp' or critical event notification indicating the far-end device is failing or losing power, and would use remote loopback control objects to run a test to confirm link integrity. Any specific object names beyond this general description would be speculative given the lack of grounding data.

Manages Ethernet OAM (Operation, Administration, Maintenance) configuration and parameters for ZTE ZXR10 network switches.