All MIBs › ZXR10-MFF-MIB
Organization: ZTE Corporation
Last Updated: 2014-04-24
Category: ZTE ZXR10 Layer 2 Switching
Description: Defines ZTE ZXR10 MAC Forced Forwarding configuration for subscriber isolation and gateway redirection.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ZXR10-MFF-MIB?
This is a ZTE-specific MIB for the ZXR10 ROSng router/switch software family, dedicated to MAC Forced Forwarding (MFF), a Layer 2 feature that isolates subscribers on a shared broadcast domain by forcing their traffic through a designated gateway rather than allowing direct peer-to-peer Layer 2 communication. It exposes configuration objects controlling MFF enablement and gateway/redirection behavior on a per-port or per-VLAN basis. Its monitoring value is primarily configuration verification rather than traffic statistics: administrators confirm that MFF is enabled where subscriber isolation is required, which is important for security compliance and preventing subscriber-to-subscriber traffic leakage in broadband access deployments. It typically works alongside standard bridge/VLAN MIBs since MFF operates on top of a switched Layer 2 domain. It is typically deployed by broadband access network operators enforcing subscriber isolation on ZXR10 switches in metro Ethernet or FTTx aggregation networks. Engineers can download the ZXR10-MFF-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in ZXR10-MFF-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- ZTE ZXR10 switch/router (ROSng-based)
Monitoring Examples
An operator checks the MFF configuration state on aggregation ports to confirm subscriber isolation is active, preventing two residential subscribers on the same VLAN from directly exchanging Layer 2 traffic. If a security audit reveals unexpected subscriber-to-subscriber connectivity, disabled or misconfigured MFF settings on the relevant port would be the first thing to check. No sample objects were present in the source extract, so exact object names cannot be confirmed here.
What Can Be Monitored
- MFF enable/disable state
- gateway redirection configuration
- per-port/VLAN isolation status
Imported Objects
From RFC1155-SMI
| TimeTicks |
From SNMPv2-SMI
| IpAddress | |
| MODULE-IDENTITY | |
| OBJECT-TYPE |
From SNMPv2-TC
| MacAddress |
From ZXR10-SMI
| zxr10RosngMIB | OBJECT-IDENTITY |
OIDs
RFC description
ZTE vendor-specific MIB for multifunction forwarding (MFF) management on ZXR10 series routing platforms.
Start monitoring ZTE ZXR10 switch/router (ROSng-based) (MAC Forced Forwarding per-port/VLAN enable config status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.