All MIBs › TERAWAVE-teraU-ds3-MIB
Category: DSL and xDSL Access, Port and Interface Management, TDM and Serial Interfaces
Description: Manages Terawave DSL access unstructured DS3 interface configuration and statistics.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is TERAWAVE-teraU-ds3-MIB?
TERAWAVE-teraU-ds3-MIB is a vendor-specific SNMP module for Terawave teraAccess platforms that manages unstructured DS3 (T3) interface configuration and line status, covering the physical transport layer beneath the ATM/DSL access service. It exposes per-line configuration such as line type, coding, cable length, transmit clock source, DS3 scrambling mode, and circuit identifier, alongside operational line status. Its monitoring relevance is squarely hardware/interface health: teraUds3LineStatus reports the current alarm/operational condition of the DS3 line, while teraUds3ValidIntervals and teraUds3TimeElasped support performance-monitoring windows typical of DS3/T3 line diagnostics, letting an operator detect line degradation or loss-of-signal conditions. This module parallels concepts from the standard DS3/E3 MIB (RFC 3896-family) for interface-layer statistics, though implemented as a Terawave-specific tree. It is deployed where a teraAccess chassis terminates DS3 backhaul or trunk circuits, with an NMS polling line status and configuration for transport-layer fault detection. Engineers can download the TERAWAVE-teraU-ds3-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in TERAWAVE-teraU-ds3-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Terawave teraAccess DS3/T3 access line card
Monitoring Examples
An operator would poll teraUds3LineStatus on teraUds3ConfigTable entries (indexed by teraUds3LineIndex) to detect an alarm condition such as loss of signal or frame on a DS3 trunk. teraUds3ConfigMdlTable and its teraUds3ConfigMdlEIC entries would be checked to confirm the maintenance data link's equipment identification code matches expected provisioning. teraUds3TimeElasped combined with teraUds3ValidIntervals lets the operator determine how much of the current 24-hour performance window has valid data before trusting an error-rate calculation.
What Can Be Monitored
- DS3 line status/alarm state
- DS3 line coding and cable length configuration
- DS3 scrambling mode
- DS3 transmit clock source
- elapsed/valid performance interval
Imported Objects
From RFC1155-SMI
| Counter | |
| Gauge | |
| OBJECT-TYPE | |
| TimeTicks | |
| enterprises |
From SNMPv2-SMI
| Counter32 | |
| Gauge32 |
OIDs
RFC description
Configures and monitors DS3 (T3) line parameters and statistics for Terawave teraU transmission equipment.
Start monitoring Terawave teraAccess DS3/T3 access line card (DS3 line status/alarm-condition monitoring) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.