All MIBs › TELDAT-CFG-PROTOCOL-NTP-MIB
Category: Teldat Router Management
Description: Configures NTP synchronization parameters on Teldat routers, including server addresses and stratum settings.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is TELDAT-CFG-PROTOCOL-NTP-MIB?
TELDAT-CFG-PROTOCOL-NTP-MIB is a Teldat proprietary configuration MIB that manages NTP (Network Time Protocol) synchronization settings on Teldat routers, including configured server addresses and stratum preferences. It exposes configuration data describing which time sources the router is set to use and how synchronization should behave, rather than raw performance counters. Reading this module back reveals the software-level time-sync configuration in force on the device - which server(s) it should be reaching and at what stratum - making it useful for confirming that a time-source change was applied correctly, since accurate device time underpins reliable event/log timestamps and trap correlation across the network. It complements the standard IETF SNMPv2-MIB sysUpTime and any NTP client status the router exposes elsewhere, since NTP correctness is foundational to trusting timestamps in traps from Teldat's many TRAP-* modules. It is deployed on Teldat routers in distributed branch networks where centralized time synchronization is required for consistent logging and security auditing. Engineers can download the TELDAT-CFG-PROTOCOL-NTP-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in TELDAT-CFG-PROTOCOL-NTP-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Teldat router
- Teldat branch-office/CPE router
Monitoring Examples
No sample object names were provided for this module, so exact OIDs cannot be cited, but the module's function corresponds to a configured NTP server address/stratum settings block similar to Teldat's other CFG-PROTOCOL-* modules. An administrator would poll this configuration after deploying a new NTP server to confirm the router picked up the intended primary/secondary time source and stratum. Persistent mismatch between configured and expected server addresses would flag a configuration push that failed to apply.
What Can Be Monitored
- configured NTP server addresses
- NTP stratum setting
- time-synchronization configuration state
Imported Objects
OIDs
RFC description
Teldat vendor-private MIB for Network Time Protocol (NTP) configuration and statistics on Teldat routing devices.
Start monitoring Teldat router/branch-office CPE router (NTP sync-source config status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.