SONOMASYSTEMS-SONOMA-IPPROP-MIB

MIB Reference — IPNetwork Monitor · Updated October 06, 2026

All MIBs › SONOMASYSTEMS-SONOMA-IPPROP-MIB

Category: SonomaSystems ATM WAN Management

Description: Manages SonomaSystems Sonoma IP interface properties including addressing, routing, and protocol parameters.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

What Is SONOMASYSTEMS-SONOMA-IPPROP-MIB?

SONOMASYSTEMS-SONOMA-IPPROP-MIB is a vendor MIB for SonomaSystems' Sonoma platform (a WAN/remote-access router product line), covering IP interface properties such as addressing, routing configuration, and other protocol-level parameters assigned to the device's network interfaces. It exposes configuration data rather than hardware sensor data, focused on how IP addressing and routing/protocol parameters are provisioned per interface. Its monitoring relevance is primarily around configuration/software status: confirming an interface's IP address, subnet, and protocol settings are correctly applied and consistent with intended routing behavior, rather than tracking temperature or CPU load. It is expected to be used alongside the standard IF-MIB and IP-MIB for baseline interface and IP-layer statistics, supplementing them with Sonoma-specific properties. Typical deployment context is small-branch or remote-office WAN routers where operators need to verify IP interface provisioning matches the intended network design. Engineers can download the SONOMASYSTEMS-SONOMA-IPPROP-MIB file directly to load it into their MIB browser.

IPNetwork Monitor allows you to monitor SNMP objects defined in SONOMASYSTEMS-SONOMA-IPPROP-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.

Supported Devices

  • SonomaSystems Sonoma WAN/branch router

Monitoring Examples

No object names were captured for this MIB, but a realistic scenario would involve polling an IP-properties table (following the vendor's typical *Table/*Entry convention, e.g., sonomaIpPropTable/sonomaIpPropEntry) to confirm the configured IP address, mask, and protocol mode on each WAN or LAN interface. An admin would cross-check these values against expected provisioning to catch a misconfigured static IP or protocol mismatch after a device replacement. Discrepancies here would typically manifest as routing or connectivity failures traceable back to interface-level IP property misconfiguration.

What Can Be Monitored

  • interface IP address assignment
  • subnet/mask configuration
  • routing protocol parameters
  • per-interface protocol mode
Imported Objects

From RFC-1212

OBJECT-TYPE

From RFC1155-SMI

Counter
IpAddress

From SONOMASYSTEMS-SONOMA-MIB

sonomaRoutingOBJECT-IDENTITY
OIDs

RFC description

IP routing protocol configuration and security properties for Sonoma Systems products.

Start monitoring SonomaSystems Sonoma WAN/branch routers with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

Download SONOMASYSTEMS-SONOMA-IPPROP-MIB