All MIBs › SONOMASYSTEMS-SONOMA-SLIP-MIB
Category: Legacy and Compatibility MIBs, SNA and Legacy WAN Protocols, SonomaSystems ATM WAN Management
Description: Manages SonomaSystems Sonoma SLIP (Serial Line Internet Protocol) interface configuration and statistics.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is SONOMASYSTEMS-SONOMA-SLIP-MIB?
SONOMASYSTEMS-SONOMA-SLIP-MIB is a vendor MIB for SonomaSystems' Sonoma router platform covering configuration and statistics for SLIP (Serial Line Internet Protocol) interfaces, an older method of running IP over serial/dial-up links. It exposes SLIP-specific interface configuration (such as line parameters and framing options) and traffic statistics for links using this protocol. Its monitoring value is centered on software/configuration status and link-level performance counters for serial WAN connections, rather than physical hardware sensors, letting operators confirm a SLIP link is up, correctly configured, and passing traffic without excessive errors. It is intended to complement the standard IF-MIB, which would report the generic interface-level operational state and counters for the same physical serial port. Typical deployment context is legacy remote/branch office routers using dial-up or leased serial lines for WAN connectivity, a technology largely superseded by PPP but still found in older Sonoma deployments. Network engineers evaluating or troubleshooting this functionality can download the SONOMASYSTEMS-SONOMA-SLIP-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in SONOMASYSTEMS-SONOMA-SLIP-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- SonomaSystems Sonoma router with serial/dial-up WAN interfaces
Monitoring Examples
No object names were captured for this MIB, but a typical scenario would involve polling a SLIP interface table (e.g., sonomaSlipIfTable/sonomaSlipIfEntry) for per-link configuration such as line speed and framing, alongside error/retransmission counters. An admin would compare SLIP-specific packet/error counts against IF-MIB's ifInErrors/ifOutErrors on the corresponding interface index to isolate protocol-level SLIP framing errors from generic physical-layer issues. A rising SLIP error count with stable IF-MIB link state would point to a serial line quality or configuration problem rather than a cable fault.
What Can Be Monitored
- SLIP interface configuration (line speed, framing)
- SLIP link operational status
- SLIP packet/error counters
Imported Objects
From RFC-1212
| OBJECT-TYPE |
| sonomaApplications | OBJECT-IDENTITY |
OIDs
RFC description
SLIP (Serial Line Internet Protocol) interface configuration for Sonoma serial devices including speed and data bits.
Start monitoring SonomaSystems Sonoma routers with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.