All MIBs › PSA-LinGlsTrap-MIB
Category: Server Hardware Monitoring
Description: Provides NEC ESMPRO ServerAgents trap notifications for GLS multipath network driver fault and failover events on Linux.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is PSA-LinGlsTrap-MIB?
PSA-LinGlsTrap-MIB is a Fujitsu Limited MIB (Copyright Fujitsu Limited 2004-2007) for the FUJITSU PRIMEQUEST server platform's partition management - despite the supplied hint and vendor attributing it to NEC ESMPRO, the source module is explicitly a Fujitsu PRIMEQUEST partition MIB, defined under the fujitsu/products/iaServer/primequest/partition enterprise tree. It defines no polled OBJECT-TYPE data objects at all; instead it is entirely a set of trap-parameter placeholders (trapPartitionName, trapUnitName, trapVendorId, trapDeviceId, trapLogicalIp, trapWatchIp, and similar, all not-accessible) that are only ever carried as VARIABLES inside its fifteen glsEvent0 through glsEvent14 TRAP-TYPE notifications. Those traps report GLS (Global Link Services, Fujitsu/Linux NIC-teaming) network faults on a PRIMEQUEST partition - link-down at trunking mode, primary/secondary polling failures, route errors, all-lines-disabled conditions, and standby-interface failures - each carrying the partition name, event level, and often a target interface/IP for correlation. Because it is a pure trap MIB with no gettable status, monitoring it means configuring the SNMP manager to receive and correlate these GLS fault traps rather than polling; it is deployed on Fujitsu PRIMEQUEST partitions running the GLS multipath network driver. Administrators can download the PSA-LinGlsTrap-MIB file to decode these traps in their trap receiver or MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in PSA-LinGlsTrap-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Fujitsu PRIMEQUEST server partitions (GLS network driver)
Monitoring Examples
A trap receiver captures a glsEvent2 trap carrying trapLogicalIp and trapWatchIp, indicating that GLS primary-path polling has failed for that logical interface on the named PRIMEQUEST partition, which would prompt an operator to check the standby path before it also fails.
What Can Be Monitored
- GLS link/trunking failure events
- primary/secondary polling failure events
- route error notifications
- all-lines-disabled and standby-interface-failed events
- partition/unit/device identification carried in traps
Imported Objects
From RFC-1212
| OBJECT-TYPE |
From RFC-1215
| TRAP-TYPE |
From RFC1155-SMI
| Counter | |
| Gauge | |
| IpAddress | |
| TimeTicks | |
| enterprises | |
| mgmt |
From RFC1213-MIB
| DisplayString | |
| mib-2 |
OIDs
RFC description
Reports GLS (Generic Linux Server) traps and fault notifications from Fujitsu PRIMEQUEST partitions.
Start monitoring Fujitsu PRIMEQUEST server partition, GLS network-teaming driver (fault traps) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.