All MIBs › ExaltComm-TRAPS-MIB
Category: Domain: Wireless, Vendor: ExaltComm
Description: Defines SNMP trap notifications for fault and status events on Exalt Communications microwave radio links.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ExaltComm-TRAPS-MIB?
ExaltComm-TRAPS-MIB is a vendor-specific MIB from Exalt Communications that defines SNMP notifications for fault and status events on Exalt's microwave point-to-point radio links, built on top of the ExaltComProducts MIB for its imported objects. It defines a set of accessible-for-notify status objects — locRadioStat and remRadioStat (local/remote radio health as GREEN/YELLOW/RED/GRAY), locRSLStat and locRSLStatVert/Horiz (received signal level state), locTempStat (temperature state), and locEthWtmkHitDurationETH1-4 (minutes since Ethernet utilization last crossed a watermark) — and wraps them into NOTIFICATION-TYPE traps such as loc-radio-stat-notif, rem-radio-stat-notif, loc-rsl-stat-notif/-vert-notif/-horiz-notif, loc-temp-stat-notif, cold-start-notif, and eth-watermark-hit-duration-notif. Because every object here is trap-only rather than polled via GET, this MIB is primarily consumed by an SNMP trap receiver rather than through periodic polling. It depends on ExaltComProducts for productsMIBNotifications, locLinkState, and modelName, and it is deployed on Exalt microwave radio links in wireless backhaul networks. Network engineers looking to integrate these alarms into an NMS commonly search for the ExaltComm-TRAPS-MIB MIB.
IPNetwork Monitor allows you to monitor SNMP objects defined in ExaltComm-TRAPS-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Exalt Communications microwave point-to-point radio links
Monitoring Examples
An NMS configured to receive SNMP traps watches for loc-radio-stat-notif carrying locRadioStat; a value of 2 (RED) combined with a subsequent loc-rsl-stat-notif reporting locRSLStat as 1 (high) or 2 (low) would indicate the local radio link has degraded, likely due to a fading or misaligned microwave path.
What Can Be Monitored
- local/remote radio status traps (GREEN/YELLOW/RED/GRAY)
- received signal level (RSL) status traps, vertical and horizontal
- temperature status traps
- Ethernet utilization watermark-hit duration
- cold-start and link-state change notifications
Imported Objects
From ExaltComProducts
| locLinkState | OBJECT-TYPE |
| modelName | OBJECT-TYPE |
| productsMIBNotifications | OBJECT-IDENTITY |
From SNMPv2-SMI
| Integer32 | |
| NOTIFICATION-TYPE | |
| OBJECT-TYPE |
OIDs
RFC description
Trap definitions for Exalt Communications wireless link status, signal quality, and equipment status monitoring.
Start monitoring Exalt Communications microwave point-to-point radio link (fault/status traps) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.