All MIBs › CISCO-DMN-DSG-MPE-MIB
Organization: Cisco systems, Inc.
Last Updated: 2010-08-30
Category: Cisco Devices, Satellite
Description: Manages Multi-Protocol Encapsulation (MPE) data stream processing on the Cisco DMN D9800 satellite receiver.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is CISCO-DMN-DSG-MPE-MIB?
CISCO-DMN-DSG-MPE-MIB is a Cisco Digital Media Network MIB specific to the Cisco DMN D9800 satellite receiver, focused on Multi-Protocol Encapsulation (MPE) used to carry IP datagrams over DVB/satellite broadcast streams. It exposes configuration data such as per-port MPE forwarding settings, IGMP/RIP enablement, and unicast routing table entries used to steer traffic across the device. It supports monitoring software/configuration status by letting an operator confirm whether MPE forwarding, IGMP, and RIP are correctly enabled per port, and by inspecting the unicast routing table for correct route/mask entries that determine how encapsulated IP traffic is delivered. As a Cisco DSG-specific MIB it is a niche, product-line module without heavy reliance on broader IETF standards. It is deployed specifically on Cisco DMN D9800 series satellite headend/receiver equipment used in cable and satellite broadcast distribution networks, where CISCO-DMN-DSG-MPE-MIB SNMP monitoring confirms MPE forwarding and routing configuration per port.
IPNetwork Monitor allows you to monitor SNMP objects defined in CISCO-DMN-DSG-MPE-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Cisco DMN D9800 satellite receiver
Monitoring Examples
An engineer would walk mpeConfigTable/mpeConfigEntry keyed by mpeConfigPortID to verify mpeConfigForwarding, mpeConfigIGMP, and mpeConfigRIP are set as expected for each port, and cross-check unicastTable/unicastEntry (unicastRoute, unicastMask) to confirm IP routes for encapsulated traffic are correctly provisioned. A port showing mpeConfigForwarding disabled when it should be active would explain why downstream set-tops are not receiving expected IP datagrams.
What Can Be Monitored
- per-port MPE forwarding status
- IGMP enablement
- RIP enablement
- unicast route/mask entries
- multipacket configuration
Imported Objects
| ciscoDSGUtilities | OBJECT-IDENTITY |
From SNMPv2-CONF
| MODULE-COMPLIANCE | |
| OBJECT-GROUP |
From SNMPv2-SMI
| Integer32 | |
| IpAddress | |
| MODULE-IDENTITY | |
| OBJECT-TYPE |
From SNMPv2-TC
| RowStatus |
OIDs
RFC description
Manages Cisco DSG Multi Protocol Encapsulation (MPE) configuration and forwarding in digital service delivery systems.
Start monitoring Cisco DMN D9800 digital satellite gateway with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.