All MIBs › ZXR10-PORT-GROUP-MIB
Organization: ZTE Corporation
Last Updated: 2018-04-21
Category: ZTE ZXR10 Layer 2 Switching
Description: Defines ZTE ZXR10 port group configuration for applying shared policies and attributes to sets of ports.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ZXR10-PORT-GROUP-MIB?
ZXR10-PORT-GROUP-MIB is a vendor-specific MIB for ZTE's ZXR10 line of carrier and enterprise switches/routers, defining a 'port group' abstraction that lets configuration and policy be applied collectively to a set of physical ports rather than one at a time. Its objects are primarily configuration-oriented, letting operators define which ports belong to a group and what shared attributes or policies apply to that group. Because port grouping is a management convenience feature rather than a runtime telemetry source, its main monitoring value is confirming group membership and configuration state matches intent, rather than exposing hardware sensors like temperature or CPU load. It depends on the underlying ZXR10 interface/port MIBs (and standard ifIndex references) to identify member ports. It is typically deployed on ZTE ZXR10 switches/routers in service-provider or enterprise networks, where administrators consult the ZXR10-PORT-GROUP-MIB MIB to manage large port counts via grouped policy.
IPNetwork Monitor allows you to monitor SNMP objects defined in ZXR10-PORT-GROUP-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- ZTE ZXR10 switch/router
Monitoring Examples
No object names were provided in sample_objects for this MIB, so a concrete example can't be grounded in real identifiers; based on the module description, one would expect a port-group table mapping a group identifier to its member port indexes and shared configuration attributes. An operator would check that a given port group's membership list matches the physical ports intended to share a VLAN or QoS policy. A port unexpectedly missing from its group would indicate a misconfiguration.
What Can Be Monitored
- port group membership
- ports assigned to each group
- group configuration attributes
Imported Objects
From SNMPv2-SMI
| Integer32 | |
| MODULE-IDENTITY | |
| OBJECT-TYPE | |
| Unsigned32 | |
| enterprises |
From SNMPv2-TC
| DisplayString |
OIDs
RFC description
Port protection group configuration for ZTE routers, managing port failover and backup strategies.
Start monitoring ZTE ZXR10 switch/router (port-group membership/shared-policy config status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.