Wellfleet-TFTP-MIB

All MIBs › Wellfleet-TFTP-MIB

Category: Wellfleet BayNetworks System Management

Description: Manages Wellfleet TFTP server parameters, active transfers, and file access control configuration.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

What Is Wellfleet-TFTP-MIB?

Wellfleet-TFTP-MIB is a Wellfleet router MIB that manages the device's built-in TFTP server, used for transferring configuration files and firmware images. It exposes configuration objects (server parameters, file access controls) and operational objects reporting active file transfers in progress. Its monitoring value lies in the software/service status of the TFTP server - confirming whether it is enabled, tracking active transfer sessions, and detecting a stalled or failed transfer during a firmware or configuration update. It is a self-contained vendor extension with no notable external MIB dependency. It is used in Wellfleet router deployments during firmware upgrades or configuration backup/restore operations initiated over the network. Engineers can download the Wellfleet-TFTP-MIB file directly to load it into their MIB browser.

IPNetwork Monitor allows you to monitor SNMP objects defined in Wellfleet-TFTP-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.

Supported Devices

Wellfleet/Bay Networks multiprotocol router

Monitoring Examples

No sample objects were provided for this module; generally an operator would poll the active-transfer objects during a firmware push to confirm a transfer is progressing and check access-control settings if a transfer is unexpectedly refused.

What Can Be Monitored

TFTP server enabled status
active transfer sessions
file access control configuration

Imported Objects

From RFC-1212

OBJECT-TYPE

From RFC1155-SMI

Counter

From Wellfleet-COMMON-MIB

wfInternet

OBJECT-IDENTITY

OIDs

OID symbolic	OID numeric	Type	Access	Description
wfTftp	1.3.6.1.4.1.18.3.5.3.6
INT wfTftpDisable	1.3.6.1.4.1.18.3.5.3.6.1	INTEGER	read-write	Enables or Disables TFTP Subsystem
INT wfTftpDefaultVolume	1.3.6.1.4.1.18.3.5.3.6.2	INTEGER	read-write	The file system volume number to which transferred files will be written and from which they will be retrieved. The volume number corresponds to the slot number on which the volume resides. On systems with a floppy disk, the value 65 represents volume 'A'. On systems which support flash file system partitioning, the volume is = (slot * 100 + partition number) where 0 and 1 are valid partition numbers, and represent 'partition a' and 'partition b' respectively. If no default volume is specified, the system chooses the lowest available active volume.
CTR wfTftpXfers	1.3.6.1.4.1.18.3.5.3.6.3	Counter	read-only	Number of Transfers in Progress
INT wfTftpTimeOut	1.3.6.1.4.1.18.3.5.3.6.4	INTEGER	read-write	General Retransmission time-out value (seconds)
INT wfTftpCloseTimeOut	1.3.6.1.4.1.18.3.5.3.6.5	INTEGER	read-write	Retransmission time-out value for sender of final ACK (seconds)
INT wfTftpRexmit	1.3.6.1.4.1.18.3.5.3.6.6	INTEGER	read-write	Maximum Number of Retransmissions
INT wfTftpIpTos	1.3.6.1.4.1.18.3.5.3.6.7	INTEGER	read-write	The Type Of Service value set in the IP datagram specifies to the Internet transport layer how the datagram should be handled. For TFTP packet transfers low delay is preferred
CTR wfTftpInFiles	1.3.6.1.4.1.18.3.5.3.6.8	Counter	read-only	Number of files Successfully received
CTR wfTftpOutFiles	1.3.6.1.4.1.18.3.5.3.6.9	Counter	read-only	Number of files Successfully sent
CTR wfTftpInWRQ	1.3.6.1.4.1.18.3.5.3.6.10	Counter	read-only	Number of write requests received
CTR wfTftpOutWRQ	1.3.6.1.4.1.18.3.5.3.6.11	Counter	read-only	Number of write requests sent
CTR wfTftpInRRQ	1.3.6.1.4.1.18.3.5.3.6.12	Counter	read-only	Number of read requests received
CTR wfTftpOutRRQ	1.3.6.1.4.1.18.3.5.3.6.13	Counter	read-only	Number of read requests sent
CTR wfTftpRexmitPkts	1.3.6.1.4.1.18.3.5.3.6.14	Counter	read-only	Number of Re-transmitted packets
CTR wfTftpInErr	1.3.6.1.4.1.18.3.5.3.6.15	Counter	read-only	Number of Error PDUs Received
CTR wfTftpOutErr	1.3.6.1.4.1.18.3.5.3.6.16	Counter	read-only	Number of Error PDUs Sent
CTR wfTftpAborts	1.3.6.1.4.1.18.3.5.3.6.17	Counter	read-only	Number of Aborted Pseudo Connections
INT wfTftpDelete	1.3.6.1.4.1.18.3.5.3.6.18	INTEGER	read-write	Create/Delete parameter. Default is created.

RFC description

Wellfleet router TFTP MIB enabling configuration of TFTP subsystem and file transfer volume settings.

Start monitoring Wellfleet/Bay Networks multiprotocol router (TFTP server enable/active-transfer status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

Download Wellfleet-TFTP-MIB

What Is Wellfleet-TFTP-MIB?

Supported Devices

Monitoring Examples

What Can Be Monitored

This MIB depends on

Related MIBs

RFC description