| OID symbolic | OID numeric | Type | Access | Description |
|---|
| ds3 | 1.3.6.1.2.1.10.30 | | | |
| ds3ConfigTable | 1.3.6.1.2.1.10.30.1 | | not-accessible | The DS3 Configuration table. |
| ds3ConfigEntry | 1.3.6.1.2.1.10.30.1.1 | | not-accessible | An entry in the DS3 Configuration table. |
| INT ds3CSUIndex | 1.3.6.1.2.1.10.30.1.1.1 | INTEGER | read-only | The index value which uniquely identifies the
CSU to which this entry is applicable. |
| INT ds3Index | 1.3.6.1.2.1.10.30.1.1.2 | INTEGER | read-only | An index value that uniquely identifies a DS3
Interface. The interface identified by a
particular value of this index is the same
interface as identified by the same value an
ifIndex object instance. |
| INT ds3TimeElapsed | 1.3.6.1.2.1.10.30.1.1.3 | INTEGER | read-only | The number of seconds, including partial
seconds, that have elapsed since the beginning of
the current error-measurement period. |
| INT ds3ValidIntervals | 1.3.6.1.2.1.10.30.1.1.4 | INTEGER | read-only | The number of previous intervals for which valid
data was collected. The value will be 96 unless
the CSU device was brought online within the last
24 hours, in which case the value will be the
number of complete 15 minute intervals the CSU has
been online. |
| INT ds3LineType | 1.3.6.1.2.1.10.30.1.1.5 | INTEGER | read-only | This variable indicates the variety of DS3 C-bit
application implementing this circuit. The type
of circuit affects the interpretation of the usage
and error statistics. The rate of all of them is
44.736 Mbps.
The values, in sequence, describe:
TITLE: SPECIFICATION:
ds3M23 ANSI T1.107-1988 [10]
ds3SYNTRAN ANSI T1.107-1988 [10]
ds3C-bitParity ANSI T1.107a-1989 [10a]
ds3ClearChannel ANSI T1.102-1987 [9] |
| INT ds3ZeroCoding | 1.3.6.1.2.1.10.30.1.1.6 | INTEGER | read-only | This variable describes the variety of Zero Code
Suppression used on the link, which in turn
affects a number of its characteristics.
ds3B3ZS refers to the use of specified patterns of
normal bits and bipolar violations which are used
to replace sequences of zero bits of a specified
length. |
| INT ds3Loopback | 1.3.6.1.2.1.10.30.1.1.7 | INTEGER | read-only | This variable represents the loopback state of
the CSU. Devices supporting read/write access
should return badValue in response to a requested
loopback state that the CSU does not support. The
values mean:
ds3NoLoop
Not in the loopback state. A device that is
not capable of performing a loopback on
either interface shall always return this as
it's value.
ds3LocalLoopbackLocalSide
Signal received from the local side of the
device is looped back at the local connector
(eg, without involving the CSU).
ds3LocalLoopbackRemoteSide
Signal received from the local side of the
device is looped back at the remote connector
(eg, through the CSU).
ds3RemoteLoopbackLocalSide
Signal received from the remote side of the
device is looped back at the local connector
(eg, through the CSU).
ds3RemoteLoopbackRemoteSide
Signal received from the remote side of the
device is looped back at the remote connector
(eg, without involving the CSU).
Note that M23 and ClearChannel interfaces do not
support the Loopback managed object. |
| INT ds3SendCode | 1.3.6.1.2.1.10.30.1.1.8 | INTEGER | read-only | This variable indicates what type of code is
being sent across the DS1 circuit by the CSU. The
values mean:
ds3SendNoCode
sending looped or normal data
ds3SendSetCode
sending a loopback request
ds3SendLoopbackCode
sending the code to choose a specific
loopback
ds3SendResetCode
sending a loopback termination request
ds3SendTestMessage
sending a Test pattern as defined in
T1.107a-1989 [10a]. |
| INT ds3YellowAlarm | 1.3.6.1.2.1.10.30.1.1.9 | INTEGER | read-only | This variable indicates if a Yellow
Alarm condition exists. |
| INT ds3RedAlarm | 1.3.6.1.2.1.10.30.1.1.10 | INTEGER | read-only | This variable indicates if a Red Alarm
condition exists. |
| STR ds3CircuitIdentifier | 1.3.6.1.2.1.10.30.1.1.11 | DisplayString | read-only | This variable contains the transmission
vendor's circuit identifier, for the
purpose of facilitating troubleshooting. |
| ds3IntervalTable | 1.3.6.1.2.1.10.30.2 | | not-accessible | The DS3 Interval table. |
| ds3IntervalEntry | 1.3.6.1.2.1.10.30.2.1 | | not-accessible | An entry in the DS3 Interval table. |
| INT ds3IntervalIndex | 1.3.6.1.2.1.10.30.2.1.1 | INTEGER | read-only | The index value which uniquely identifies the
CSU to which this entry is applicable. The
interface identified by a particular value of
this index is the same interface as identified
by the same value an DS3CSUIndex object
instance. |
| INT ds3IntervalNumber | 1.3.6.1.2.1.10.30.2.1.2 | INTEGER | read-only | A number between 1 and 96, where 1 is the most
recently completed 15 minute interval and 96 is
the least recently completed 15 minutes
interval (assuming that all 96 intervals are
valid). |
| CTR ds3IntervalESs | 1.3.6.1.2.1.10.30.2.1.3 | Counter | read-only | The counter associated with the number of
Errored Seconds, as defined by [12], encountered
by a DS3 CSU in one of the previous 96,
individual 15 minute, intervals. |
| CTR ds3IntervalSESs | 1.3.6.1.2.1.10.30.2.1.4 | Counter | read-only | The counter associated with the number of
Severely Errored Seconds, as defined by [12],
encountered by a DS3 CSU in one of the previous
96, individual 15 minute, intervals. |
| CTR ds3IntervalSEFSs | 1.3.6.1.2.1.10.30.2.1.5 | Counter | read-only | The counter associated with the number of
Severely Errored Framing Seconds, as defined by
[12], encountered by a DS3 CSU in one of the
previous 96, individual 15 minute, intervals. |
| CTR ds3IntervalUASs | 1.3.6.1.2.1.10.30.2.1.6 | Counter | read-only | The counter associated with the number of
Unavailable Seconds, as defined by [12],
encountered by a DS3 CSU in one of the previous
96, individual 15 minute, intervals. |
| CTR ds3IntervalCSSs | 1.3.6.1.2.1.10.30.2.1.7 | Counter | read-only | The counter associated with the number of
Controlled Slip Seconds, as defined by [12],
encountered by a DS3 CSU in one of the previous
96, individual 15 minute, intervals.
Note that SYNTRAN interfaces are the only
interfaces that support the Controlled Slip
Seconds managed object. Accordingly, agents
configured with non-SYNTRAN interfaces may treat
this object as having an ACCESS clause value of
not-accessible. |
| CTR ds3IntervalBPVs | 1.3.6.1.2.1.10.30.2.1.8 | Counter | read-only | The counter associated with the number of Bipolar
Violations, as defined by [12], encountered by a
DS3 CSU in one of the previous 96, individual 15
minute, intervals. |
| CTR ds3IntervalCVs | 1.3.6.1.2.1.10.30.2.1.9 | Counter | read-only | The counter associated with the number of Coding
Violations, as defined by [12], encountered by a
DS3 CSU in one of the previous 96, individual 15
minute, intervals. |
| ds3CurrentTable | 1.3.6.1.2.1.10.30.3 | | not-accessible | The DS3 Current table. |
| ds3CurrentEntry | 1.3.6.1.2.1.10.30.3.1 | | not-accessible | An entry in the DS3 Current table. |
| INT ds3CurrentIndex | 1.3.6.1.2.1.10.30.3.1.1 | INTEGER | read-only | The index value which uniquely identifies the CSU
to which this entry is applicable. The interface
identified by a particular value of this index is
the same interface as identified by the same value
an DS3CSUIndex object instance. |
| CTR ds3CurrentESs | 1.3.6.1.2.1.10.30.3.1.2 | Counter | read-only | The counter associated with the number of Errored
Seconds, as defined by [12], encountered by a DS3
CSU in the current 15 minute interval. |
| CTR ds3CurrentSESs | 1.3.6.1.2.1.10.30.3.1.3 | Counter | read-only | The counter associated with the number of
Severely Errored Seconds, as defined by [12],
encountered by a DS3 CSU in the current 15 minute
interval. |
| CTR ds3CurrentSEFSs | 1.3.6.1.2.1.10.30.3.1.4 | Counter | read-only | The counter associated with the number of
Severely Errored Framing Seconds, as defined by
[12], encountered by a DS3 CSU in the current 15
minute interval. |
| CTR ds3CurrentUASs | 1.3.6.1.2.1.10.30.3.1.5 | Counter | read-only | The counter associated with the number of
Unavailable Seconds, as defined by [12],
encountered by a DS3 CSU in the current 15 minute
interval. |
| CTR ds3CurrentCSSs | 1.3.6.1.2.1.10.30.3.1.6 | Counter | read-only | The counter associated with the number of
Controlled Slip Seconds, as defined by [12],
encountered by a DS3 CSU in the current 15 minute
interval.
Note that SYNTRAN interfaces are the only
interfaces that support the Controlled Slip
Seconds managed object. Accordingly, agents
configured with non-SYNTRAN interfaces may treat
this object as having an ACCESS clause value of
not-accessible. |
| CTR ds3CurrentBPVs | 1.3.6.1.2.1.10.30.3.1.7 | Counter | read-only | The counter associated with the number of Bipolar
Violations, as defined by [12], encountered by a
DS3 CSU in the current 15 minute interval. |
| CTR ds3CurrentCVs | 1.3.6.1.2.1.10.30.3.1.8 | Counter | read-only | The counter associated with the number of Coding
Violations, as defined by [12], encountered by a
DS3 CSU in the current 15 minute interval. |
| ds3TotalTable | 1.3.6.1.2.1.10.30.4 | | not-accessible | The DS3 Total table. 24 hour interval. |
| ds3TotalEntry | 1.3.6.1.2.1.10.30.4.1 | | not-accessible | An entry in the DS3 Total table. |
| INT ds3TotalIndex | 1.3.6.1.2.1.10.30.4.1.1 | INTEGER | read-only | The index value which uniquely identifies the CSU
to which this entry is applicable. The interface
identified by a particular value of this index is
the same interface as identified by the same value
an DS3CSUIndex object instance. |
| CTR ds3TotalESs | 1.3.6.1.2.1.10.30.4.1.2 | Counter | read-only | The counter associated with the number of Errored
Seconds, as defined by [12], encountered by a DS3
CSU in the previous 24 hour interval. |
| CTR ds3TotalSESs | 1.3.6.1.2.1.10.30.4.1.3 | Counter | read-only | The counter associated with the number of
Severely Errored Seconds, as defined by [12],
encountered by a DS3 CSU in the previous 24 hour
interval. |
| CTR ds3TotalSEFSs | 1.3.6.1.2.1.10.30.4.1.4 | Counter | read-only | The counter associated with the number of
Severely Errored Framing Seconds, as defined by
[12], encountered by a DS3 CSU in the previous 24
hour interval. |
| CTR ds3TotalUASs | 1.3.6.1.2.1.10.30.4.1.5 | Counter | read-only | The counter associated with the number of
Unavailable Seconds, as defined by [12],
encountered by a DS3 CSU in the previous 24 hour
interval. |
| CTR ds3TotalCSSs | 1.3.6.1.2.1.10.30.4.1.6 | Counter | read-only | The counter associated with the number of
Controlled Slip Seconds, as defined by [12],
encountered by a DS3 CSU in the previous 24 hour
interval.
Note that SYNTRAN interfaces are the only
interfaces that support the Controlled Slip
Seconds managed object. Accordingly, agents
configured with non-SYNTRAN interfaces may treat
this object as having an ACCESS clause value of
not-accessible. |
| CTR ds3TotalBPVs | 1.3.6.1.2.1.10.30.4.1.7 | Counter | read-only | The counter associated with the number of Bipolar
Violations, as defined by [12], encountered by a
DS3 CSU in the previous 24 hour interval. |
| CTR ds3TotalCVs | 1.3.6.1.2.1.10.30.4.1.8 | Counter | read-only | The counter associated with the number of Coding
Violations, as defined by [12], encountered by a
DS3 CSU in the previous 24 hour interval. |
