All MIBs › RAD-MIB › ip2IfCustomToneDetect
ip2IfCustomToneDetect
Module: RAD-MIB
OID (symbolic): RAD-MIB::ip2IfCustomToneDetect
OID (numeric): 1.3.6.1.4.1.164.3.1.6.7.1.1.43
Node type: OBJECT-TYPE
Type: INTEGER
Access: read-create
Description:
Custom Tone Detection (COT) is a Control operation of a 2Khz tone detector. This tone is sent between PBX devices in order to check that the line status is OK. When the COT is enabled the device will not compress/decompress the tone. In this case, if the tone is initiated by the local PBX, the Device runs a 2Khz detector tone and once detected by the Remote Device, if the COT is enabled in the Remote Device, the Remote Device will generate a 2khz tone to the remote PBX.
What is ip2IfCustomToneDetect?
This object controls Custom Tone Detection (COT), a feature that suppresses compression of a 2 kHz tone used for line-quality monitoring between PBX devices over data network links. When enabled, the device passes the tone through uncompressed so remote devices can verify the line is functioning correctly without compression artifacts distorting the signal. Telecommunications operators enable this feature when interconnecting legacy PBX systems over packet networks to maintain traditional line-quality verification mechanisms.
OID Breakdown
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | BIANCA-BRICK-PPP-MIB |
| 1.3.6 | dod | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1 | internet | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1.4 | private | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1.4.1 | enterprises | ANIROOT-MIB |
| 1.3.6.1.4.1.164 | rad | DACS-MIB |
| 1.3.6.1.4.1.164.3 | radWan | DACS-MIB |
| 1.3.6.1.4.1.164.3.1 | wanGen | DACS-MIB |
| 1.3.6.1.4.1.164.3.1.6 | diverseIfWanGen | DACS-MIB |
| 1.3.6.1.4.1.164.3.1.6.7 | ip2If | RAD-MIB |
| 1.3.6.1.4.1.164.3.1.6.7.1 | ip2IfTable | RAD-MIB |
| 1.3.6.1.4.1.164.3.1.6.7.1.1 | ip2IfEntry | RAD-MIB |
| 1.3.6.1.4.1.164.3.1.6.7.1.1.43 | ip2IfCustomToneDetect | RAD-MIB |