All MIBs › HILLSTONE-IP-MIB
Category: LAN Management
Description: Manages IP address and routing configurations on Hillstone Networks firewalls.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is HILLSTONE-IP-MIB?
HILLSTONE-IP-MIB is a Hillstone Networks vendor MIB that manages IP address and routing configuration on Hillstone firewalls, though the object list available is limited to a top-level address-family object and the module's objects container, with no module identity text or table-level detail supplied. Based on its short description, it is expected to expose IP addressing configuration (and possibly address-family-specific routing parameters) rather than sensor/environmental data. Its monitoring relevance would be primarily configuration-verification (confirming IPv4/IPv6 addressing is applied as intended) rather than hardware or software health, though the supplied excerpt does not include enough object detail to describe deeper runtime status. It likely depends on or parallels standard IP-MIB conventions for address-family handling. It is deployed on Hillstone Networks firewall/security-gateway appliances, where HILLSTONE-IP-MIB SNMP monitoring can confirm IP addressing configuration is applied as intended.
IPNetwork Monitor allows you to monitor SNMP objects defined in HILLSTONE-IP-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Hillstone Networks firewalls/security gateways
Monitoring Examples
The provided object list for this MIB contains only hillstoneIpAddressFamily and the hillstoneIpObjects container, without table-level detail, so a concrete polling scenario with realistic per-interface or per-route objects cannot be constructed from the given source.
What Can Be Monitored
- configured IP address family (IPv4/IPv6)
Imported Objects
From HILLSTONE-SMI
| hillstoneIp | OBJECT-IDENTITY |
From RFC-1212
| OBJECT-TYPE |
OIDs
RFC description
Hillstone Networks IP address family support including IPv4, IPv6, and other protocols.
Start monitoring Hillstone Networks firewall/security gateway (IP addressing) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.