HDSL710D2-MIB

Description: Manages HDSL 710D2 modem units, providing loop performance, alarm, and configuration objects for DSL access.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

HDSL710D2-MIB is a vendor MIB from GDC (General DataComm) for managing the 710D2 HDSL modem unit, providing loop performance, alarm, and configuration monitoring for this HDSL access device used to deliver digital leased-line service over copper pairs. It exposes system and version identification (including a distinct GDC MIB-version object), and a dedicated alarms group covering specific fault conditions: no-response alarm, diagnostic receive-error alarm, and power-up alarm. This is squarely a hardware fault/status monitoring MIB for a telecom access device: an administrator uses it to detect when the remote modem stops responding, when receive-side diagnostics indicate line errors, or when the unit has recently power-cycled (which could explain a service interruption). As a standalone modem MIB it depends only on basic system-identification conventions rather than other management MIBs. It is deployed at customer premises or carrier central-office-adjacent sites using GDC HDSL 710D2 units to provide dedicated digital circuits over existing copper infrastructure. Network engineers evaluating or troubleshooting this functionality can download the HDSL710D2-MIB file directly to load it into their MIB browser.

An administrator would poll hdsl710D2NoResponseAlm to detect a remote unit that has stopped answering, which typically indicates a line cut or hardware failure, and would check hdsl710D2DiagRxErrAlm for receive-side error conditions suggesting line-quality degradation such as noise or attenuation on the copper pair. hdsl710D2PowerUpAlm would flag if the modem has recently rebooted (e.g. due to a power interruption), helping correlate a reported outage with a hardware power event. hdsl710D2Version and gdc710D2SystemMIBversion would be checked to confirm firmware and MIB compatibility when troubleshooting with vendor support.

General DataComm HDSL 710D2 system MIB for version and alarm management.