All MIBs › HDSL700AG2-MIB
Category: DSL and Broadband
Description: Manages HDSL 700AG2 modem units, providing loop performance, alarm, and configuration objects for DSL access.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is HDSL700AG2-MIB?
HDSL700AG2-MIB is a vendor MIB from GDC (General DataComm) for managing the 700AG2 family of HDSL (High-bit-rate Digital Subscriber Line) modem/termination units used to deliver DSL access circuits. It exposes system identification, versioning, and an extensive set of alarm objects covering conditions like loss of response, receive errors, and power-up events on the HDSL line. This MIB is squarely a hardware/fault-monitoring MIB: it lets an operator track whether the HDSL unit is powered and responding (via no-response alarms), detect line-quality degradation (via diagnostic receive-error alarms), and confirm firmware/hardware version via hdsl700AG2Version/gdc700AG2SystemMIBversion. It is a self-contained vendor MIB with no strong stated dependency on other standard MIBs beyond standard SNMP SMI conventions. It is typically deployed in telco or enterprise HDSL loop-extension equipment providing leased-line or DSL access circuits at a remote site. Engineers can download the HDSL700AG2-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in HDSL700AG2-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- GDC (General DataComm) HDSL 700AG2 modem/termination unit
Monitoring Examples
An admin would poll hdsl700AG2NoResponseAlm to detect if the remote HDSL unit has stopped responding, indicating a power or link failure, and hdsl700AG2DiagRxErrAlm to catch elevated receive errors suggesting line noise or a marginal loop. A hdsl700AG2PowerUpAlm event correlated with a gap in polling would confirm the unit rebooted, possibly due to a power outage at the remote site. hdsl700AG2Version and gdc700AG2SystemMIBversion would be checked to confirm firmware consistency across a fleet of units.
What Can Be Monitored
- no-response alarm
- receive error diagnostic alarm
- power-up alarm event
- firmware/system MIB version
Imported Objects
OIDs
RFC description
GDC HDSL 700AG2 DSL system alarms, version, and high-speed digital subscriber line management.
Start monitoring General DataComm (GDC) HDSL modem/line-termination unit (700AG2) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.