HDSL700G2-MIB

Description: Manages HDSL 700G2 modem units, providing loop performance, alarm, and configuration objects for DSL access.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

HDSL700G2-MIB is a vendor-specific MIB (from GDC, General DataComm) for managing the HDSL 700G2 High-bit-rate Digital Subscriber Line modem, a device used to extend digital circuits over ordinary copper pairs for DSL-based access networks. It exposes system identification and firmware/hardware version objects (hdsl700G2System, hdsl700G2Version) along with, per its documented scope, loop performance, alarm, and configuration parameters for the DSL line. Monitoring-wise this MIB is used for hardware status of the modem unit and its DSL loop — tracking firmware/hardware version for inventory purposes and alarm conditions that indicate a failing or resetting line — rather than higher-layer traffic statistics. It is a legacy, largely self-contained modem MIB with minimal dependency on IETF standard MIBs beyond generic SNMPv2 conventions typical of that era's DSL equipment. It's deployed at telco or enterprise demarcation points where an HDSL 700G2 unit terminates a leased-line circuit over copper. Network engineers evaluating or troubleshooting this functionality can download the HDSL700G2-MIB file directly to load it into their MIB browser.

An administrator would poll hdsl700G2Version to confirm the modem's firmware/hardware revision matches the fleet baseline, useful when troubleshooting inconsistent behavior across a batch of deployed units. Objects under hdsl700G2System would be checked for basic system identification and status, and — consistent with this MIB's documented alarm and loop-performance scope — any active alarm condition on the HDSL loop (such as loss of signal or a power-up reset) would indicate a physical line fault requiring a line test or truck roll.

MIB for GDC HDSL 700G2 modem monitoring with alarms for signal quality, synchronization, and line errors.