DNOS-IPV6-LOOPBACK-MIB

Description: Manages IPv6 loopback interface configuration and address assignment on Dell DNOS network devices.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

DNOS-IPV6-LOOPBACK-MIB is a Dell Networking private MIB for configuring IPv6 addresses on loopback interfaces of DNOS-based network devices. It exposes objects for creating loopback interfaces and assigning them IPv6 addresses and prefixes. Its monitoring value is mainly configuration-state verification rather than hardware health: confirming a loopback interface exists and holds the expected IPv6 address is useful for validating router-ID/management addressing used by routing protocols, and a missing or unexpected address would explain a routing-adjacency or management-reachability failure. It is likely built on IETF address textual conventions (e.g., InetAddressType) layered under Dell's private DNOS MIB tree, though no explicit dependency is stated in the source. It is deployed on Dell EMC Networking DNOS switches/routers that use loopback interfaces for BGP/OSPF router IDs or out-of-band management addressing, with the DNOS-IPV6-LOOPBACK-MIB MIB exposing the objects administrators poll to confirm that configuration.

No sample object names were provided for this module; generically, an admin would poll the loopback interface table for its assigned IPv6 address and prefix, and its administrative state, to confirm the interface used as a routing-protocol source address is correctly configured and up.

Manages IPv6 loopback interface address configuration on Dell Networking OS switches.