Description: Special operational mode. Value of 1 indicates the mode is enabled. dqossf10cms - Allow 1.0 CMs to be stored in DocsQosServiceFlowEntry adjrxpwrctl - Allow rx power control to be adjusted by mod type usage enbudptcpfltr - Allow combining of Udp and Tcp messages in a single filter upce - Allow Upstream Packet Classifier Enforcement use16ForDSPeakTrafficRate - use the defunct TLV type 16 for DS peak traffic rate cpeNacksForceCmReset - - Force CM reset upon receiving 3 consecutive CPE NACKs loadBalUnbondedVoipOn - Allow load balancing for non-bonded voice calls limitUsRngRspFreqOff - Prevent CM from using an upstream frequency beyond 42 MHz upDownTrapIfDescrOff - Allow linkup or linkdown trap to include ifDescr ofdmSparingCleanupOff - Allow automatically reset any D3.1 CMs in a cable-mac that has an OFDM channel on that DCAM in the CM's RCS after a failover or fallback cmstatusoperational - Support DOCS-IF-MIB draft-05 (cw26)'s change to docsIfCmtsCmStatusValue, such that online modems take on a value of operational(8) at the CMTS. If disabled, operational(8) is not used and online modems take on a value of registrationComplete(6) at the CMTS. docsis20test - Allow running of DOCSIS 2.0 Tests. showCmFormatCVOff - show cable modem is formatted per CableVision's requirements if set to 0. docsis10plusOff - DOCSIS 1.0+ support is enabled if set to 0. downstreamOverrideOn - downstream overrides are disabled if this is set to 0. supressDCDOff - DCDs are suppressed if set to 0. virtualCmOff - support for virtual modems is enabled if set to 0. bpiHybridOff - Allow DOCSIS 1.1 modems to operate in BPI instead of BPI+ if this is set to 0. oneDCmDSMaxTrafBurstOn - Override Max Traffic Burst for DOCSIS 1.1 modems on a 1D CAM with E6000 setting if this is set to 0. docsis30ReqTxPolicyChkOff - Override DOCSIS 3.0 checking for Request/Transmission Policy TLV on upstream flows.