All MIBs › ZXR10-MSTATIC-MIB
Organization: ZTE Corporation
Last Updated: 2008-11-24
Category: ZTE ZXR10 Multicast
Description: Defines ZTE ZXR10 static multicast route entries for manually configured multicast forwarding paths.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ZXR10-MSTATIC-MIB?
This is a ZTE-specific private MIB for the ZXR10 router family, dedicated to statically configured IP multicast routes — forwarding entries manually defined by an administrator rather than learned dynamically through PIM or other multicast routing protocols. It exposes both summary counters and detailed route table entries describing source and group addresses, incoming interface, and per-outgoing-interface forwarding state. Its monitoring value lies in verifying multicast forwarding configuration: administrators use ipMstaticRouteSGCount and ipMstaticRouteXGCount to get quick counts of (S,G) and (*,G) static entries, and drill into ipMstaticRouteTable/ipMstaticOifRouteTable to confirm that specific source/group pairs are correctly bound to the intended incoming and outgoing interfaces, plus check ipMstaticRouteTimeStamp for when an entry was last modified. It typically supplements dynamic multicast routing MIBs (e.g., PIM-MIB, IPMROUTE-MIB) in networks that mix static and dynamic multicast forwarding. It is typically deployed by network engineers maintaining manually engineered multicast distribution paths on ZXR10 routers, such as for IPTV backbone delivery. Network engineers evaluating or troubleshooting this functionality can download the ZXR10-MSTATIC-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in ZXR10-MSTATIC-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- ZTE ZXR10 router
Monitoring Examples
An engineer checks ipMstaticRouteSGCount to confirm the expected number of static (S,G) multicast entries are present after a configuration change, then inspects ipMstaticRouteTable entries like ipMstaticRouteSourceAddr, ipMstaticRouteGroupAddr, and ipMstaticRouteIifAddr to verify a specific stream's source and incoming interface binding are correct. If a multicast stream fails to reach a downstream router, cross-referencing ipMstaticOifRouteTable entries (ipMstaticRouteOifSourceAddr/ipMstaticRouteOifGroupAddr) can reveal a missing or misconfigured outgoing interface for that group.
What Can Be Monitored
- static (S,G) route count
- static (*,G) route count
- static route source/group address
- incoming interface binding
- outgoing interface binding
- route entry last-modified timestamp
Imported Objects
From SNMPv2-SMI
| IpAddress | |
| MODULE-IDENTITY | |
| OBJECT-TYPE | |
| Unsigned32 | |
| enterprises |
From SNMPv2-TC
| TimeStamp |
OIDs
RFC description
ZTE vendor-private MIB for management of IP static multicast routing in ZXR10 series routers.
Start monitoring ZTE ZXR10 router (static multicast-route source-group/incoming-outgoing-interface status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.