ZTE-AN-INTERFACE-STATS-MIB :: zxAnEthIfInJabbers

MIB Reference — IPNetwork Monitor · Updated October 06, 2026

All MIBs › ZTE-AN-INTERFACE-STATS-MIB › zxAnEthIfInJabbers

zxAnEthIfInJabbers

Module: ZTE-AN-INTERFACE-STATS-MIB

OID (symbolic): ZTE-AN-INTERFACE-STATS-MIB::zxAnEthIfInJabbers

OID (numeric): 1.3.6.1.4.1.3902.1082.30.31.2.2.1.32

Node type: OBJECT-TYPE

Type: Counter64

Access: read-only

Description: The total number of packets received that were longer than 1518 octets (excluding framing bits, but including FCS octets), and had either a bad Frame Check Sequence (FCS) with an integral number of octets (FCS Error) or a bad FCS with a non-integral number of octets (Alignment Error).

Note that this definition of jabber is different than the definition in IEEE-802.3 section 8.2.1.5 (10BASE5) and section 10.3.1.4 (10BASE2). These documents define jabber as the condition where any packet exceeds 20 ms. The allowed range to detect jabber is between 20 ms and 150 ms.

What is zxAnEthIfInJabbers?

A count of oversized frames (over 1518 octets) received on this Ethernet port that also have a bad FCS -- classic jabber, and the DESCRIPTION notes this length-based definition differs from the older IEEE 802.3 time-based jabber definition (any packet exceeding 20-150 ms).

Examples

Walk all instances (SNMPv2c):

snmpwalk -v2c -c public <target> 1.3.6.1.4.1.3902.1082.30.31.2.2.1.32
snmpwalk -v2c -c public <target> ZTE-AN-INTERFACE-STATS-MIB::zxAnEthIfInJabbers

Get a specific instance (index 1):

snmpget -v2c -c public <target> 1.3.6.1.4.1.3902.1082.30.31.2.2.1.32.1
snmpget -v2c -c public <target> ZTE-AN-INTERFACE-STATS-MIB::zxAnEthIfInJabbers.1

Start monitoring ZTE Access Node (AN) broadband access / DSLAM-class equipment (Ethernet/bridge/LAG/VLAN traffic-statistics status) with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the ZTE-AN-INTERFACE-STATS-MIB::zxAnEthIfInJabbers OID value, configure state conditions and alerts, and monitor any ZTE Access Node (AN) broadband access / DSLAM-class equipment (Ethernet/bridge/LAG/VLAN traffic-statistics status) from a single console.

OID Breakdown

Upper-level ancestors (9 from the standard OID tree / other modules)
Numeric OIDNameModule
1isoLANART-AGENT
1.3orgAirPair-MIB
1.3.6dodAirPair-MIB
1.3.6.1internetAirPair-MIB
1.3.6.1.4privateAirPair-MIB
1.3.6.1.4.1enterprisesAirPair-MIB
1.3.6.1.4.1.3902zteDPI-MIB
1.3.6.1.4.1.3902.1082zxAccessNodeZTE-AN-SMI
1.3.6.1.4.1.3902.1082.30zxAnInterfaceZTE-AN-SMI
Numeric OIDNameModule
1.3.6.1.4.1.3902.1082.30.31zxAnInterfaceStatsMibZTE-AN-INTERFACE-STATS-MIB
1.3.6.1.4.1.3902.1082.30.31.2zxAnIfPerfObjectsZTE-AN-INTERFACE-STATS-MIB
1.3.6.1.4.1.3902.1082.30.31.2.2zxAnEthIfCurrStatsTableZTE-AN-INTERFACE-STATS-MIB
1.3.6.1.4.1.3902.1082.30.31.2.2.1zxAnEthIfCurrStatsEntryZTE-AN-INTERFACE-STATS-MIB
1.3.6.1.4.1.3902.1082.30.31.2.2.1.32zxAnEthIfInJabbersZTE-AN-INTERFACE-STATS-MIB