Wellfleet-FNTS-ATM-MIB

All MIBs › Wellfleet-FNTS-ATM-MIB

Category: Wellfleet BayNetworks ATM

Description: Manages Wellfleet FNTS ATM service parameters and virtual circuit provisioning statistics.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

What Is Wellfleet-FNTS-ATM-MIB?

Wellfleet-FNTS-ATM-MIB is a vendor-specific SNMP module from Wellfleet Communications (later part of Bay Networks/Nortel) covering ATM service parameters and virtual circuit (VC) provisioning on Wellfleet routers. It exposes configuration and status data for ATM service parameters and per-VC provisioning statistics, including connection state. As a hardware/software status MIB it is used to confirm ATM interface modules and their configured circuits are operationally up, to track VC provisioning success or failure, and to spot connectivity faults on ATM trunks. It builds on standard ATM-MIB / IETF ATM interface conventions while adding Wellfleet-specific provisioning objects, so it is typically polled alongside RFC-based ATM and interface MIBs. It would be deployed in legacy WAN environments where Wellfleet/Bay Networks routers provided ATM uplinks for enterprise or carrier backbones, typically inspected using a Wellfleet-FNTS-ATM-MIB MIB Browser for direct object review.

IPNetwork Monitor allows you to monitor SNMP objects defined in Wellfleet-FNTS-ATM-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.

Supported Devices

Wellfleet/Bay Networks router
ATM WAN interface module

Monitoring Examples

An administrator would poll the module's ATM virtual-circuit table to confirm each provisioned PVC/SVC remains in the 'up' operational state and to read per-circuit statistics. A sudden drop in active VC count or a shift in circuit operational status would indicate an ATM trunk failure or misconfiguration on the router's ATM interface card. No sample object names were available for this MIB, so this scenario is inferred from its short description rather than confirmed object names.

What Can Be Monitored

ATM virtual circuit status
VC provisioning state
per-circuit statistics
ATM interface operational status

Imported Objects

From RFC-1212

OBJECT-TYPE

From RFC1155-SMI

Counter
IpAddress

From Wellfleet-COMMON-MIB

wfFntsAtmGroup

OBJECT-IDENTITY

OIDs

OID symbolic	OID numeric	Type	Access	Description
wfFntsAtmTable	1.3.6.1.4.1.18.3.4.32.1		not-accessible	Fnts Atm line record
wfFntsAtmEntry	1.3.6.1.4.1.18.3.4.32.1.1		not-accessible	An entry in the FntsAtm table
INT wfFntsAtmDelete	1.3.6.1.4.1.18.3.4.32.1.1.1	INTEGER	read-write	create/delete parameter, dflt = created
INT wfFntsAtmDisable	1.3.6.1.4.1.18.3.4.32.1.1.2	INTEGER	read-write	enable/disable parameter, dflt = enabled
INT wfFntsAtmState	1.3.6.1.4.1.18.3.4.32.1.1.3	INTEGER	read-only	line driver state variable, Not Present, Init, Down, Up
INT wfFntsAtmSlot	1.3.6.1.4.1.18.3.4.32.1.1.4	INTEGER	read-only	instance ID Slot, filled in by driver
INT wfFntsAtmConnector	1.3.6.1.4.1.18.3.4.32.1.1.5	INTEGER	read-only	instance ID Connector, filled in by driver. For the ASN this attribute is an encoded value and is equal to 'module'*10 + 'connector'. Where 'module' is defined in attribute 42 and 'connector' is defined in attribute 43 of this table. For non-ASN platforms this attribute is the physical connector number on the slot.
INT wfFntsAtmCct	1.3.6.1.4.1.18.3.4.32.1.1.6	INTEGER	read-write	cct number for this line instance
INT wfFntsAtmMtu	1.3.6.1.4.1.18.3.4.32.1.1.7	INTEGER	read-write	mtu parameter, fixed
OCT wfFntsAtmMadr	1.3.6.1.4.1.18.3.4.32.1.1.8	OCTET STRING	read-only	line MAC address, fixed - line driver fills in
IP wfFntsAtmIpAdr	1.3.6.1.4.1.18.3.4.32.1.1.9	IpAddress	read-only	Ip Address, for the Sonet RPU
INT wfFntsAtmAtmState	1.3.6.1.4.1.18.3.4.32.1.1.10	INTEGER	read-only	line driver state variable, Not Present, Init, Down, Up
INT wfFntsAtmSpeed	1.3.6.1.4.1.18.3.4.32.1.1.11	INTEGER	read-only	Atm Interface speed in Meg bps.
CTR wfFntsAtmRxOctets	1.3.6.1.4.1.18.3.4.32.1.1.12	Counter	read-only	counts the number of bytes received from the Atm interface.
CTR wfFntsAtmRxFrames	1.3.6.1.4.1.18.3.4.32.1.1.13	Counter	read-only	counts the number of frames received from the Atm interface.
CTR wfFntsAtmTxOctets	1.3.6.1.4.1.18.3.4.32.1.1.14	Counter	read-only	counts the number of bytes sent to the Atm interface.
CTR wfFntsAtmTxFrames	1.3.6.1.4.1.18.3.4.32.1.1.15	Counter	read-only	counts the number of frames sent to the Atm interface.
CTR wfFntsAtmLackRescErrorRx	1.3.6.1.4.1.18.3.4.32.1.1.16	Counter	read-only	counts the number of requested buffers not available to the driver.
CTR wfFntsAtmInErrors	1.3.6.1.4.1.18.3.4.32.1.1.17	Counter	read-only	counts the number of errors on the receive side of the driver.
CTR wfFntsAtmOutErrors	1.3.6.1.4.1.18.3.4.32.1.1.18	Counter	read-only	counts the number of errors on the transmit side of the driver.
CTR wfFntsAtmRxLongFrames	1.3.6.1.4.1.18.3.4.32.1.1.19	Counter	read-only	counts the number of received frames too long.
CTR wfFntsAtmTxClipFrames	1.3.6.1.4.1.18.3.4.32.1.1.20	Counter	read-only	counts the number of transmit frames dropped because of no transmit queue space.
CTR wfFntsAtmRxReplenMisses	1.3.6.1.4.1.18.3.4.32.1.1.21	Counter	read-only	counts the number of the buffer requests without response.
CTR wfFntsAtmRxOverruns	1.3.6.1.4.1.18.3.4.32.1.1.22	Counter	read-only	counts the number of receiver overruns.
CTR wfFntsAtmRxRingErrors	1.3.6.1.4.1.18.3.4.32.1.1.23	Counter	read-only	counts the number of receiver ring errors.
CTR wfFntsAtmTxRingErrors	1.3.6.1.4.1.18.3.4.32.1.1.24	Counter	read-only	counts the number of transmit ring errors.
CTR wfFntsAtmOpErrors	1.3.6.1.4.1.18.3.4.32.1.1.25	Counter	read-only	counts the number of operational driver errors.
CTR wfFntsAtmRxProcessings	1.3.6.1.4.1.18.3.4.32.1.1.26	Counter	read-only	counts the number of times the receive processing has been called.
CTR wfFntsAtmTxProcessings	1.3.6.1.4.1.18.3.4.32.1.1.27	Counter	read-only	counts the number of times the transmit processing has been called.
CTR wfFntsAtmTxCmplProcessings	1.3.6.1.4.1.18.3.4.32.1.1.28	Counter	read-only	counts the number of times the transmit complete processing has been called.
CTR wfFntsAtmIntrProcessings	1.3.6.1.4.1.18.3.4.32.1.1.29	Counter	read-only	counts the number of times the interrupt service routine has been called
CTR wfFntsAtmSintProcessings	1.3.6.1.4.1.18.3.4.32.1.1.30	Counter	read-only	counts the number of times the change state interrupt has been called.
CTR wfFntsAtmPintProcessings	1.3.6.1.4.1.18.3.4.32.1.1.31	Counter	read-only	counts the number of times the primitive interrupt service routine has been called.
INT wfFntsAtmRxRingLength	1.3.6.1.4.1.18.3.4.32.1.1.32	INTEGER	read-write	Atm Interface Receiver Ring Length.
INT wfFntsAtmTxRingLength	1.3.6.1.4.1.18.3.4.32.1.1.33	INTEGER	read-write	Atm Interface Transmit Ring Length.
INT wfFntsAtmCfgRxQueueLength	1.3.6.1.4.1.18.3.4.32.1.1.34	INTEGER	read-write	Atm Configurable receive queue length.
INT wfFntsAtmCfgTxQueueLength	1.3.6.1.4.1.18.3.4.32.1.1.35	INTEGER	read-write	Atm Configurable transmit queue length.
INT wfFntsAtmLineNumber	1.3.6.1.4.1.18.3.4.32.1.1.36	INTEGER	read-write	Unique number identifying this interface.

RFC description

Vendor-private MIB for Wellfleet ATM networking equipment, providing FNTS (Frame and Tributary Service) management.

Start monitoring Wellfleet/Bay Networks router, ATM WAN interface module (ATM VC provisioning/connection-state status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

Download Wellfleet-FNTS-ATM-MIB

What Is Wellfleet-FNTS-ATM-MIB?

Supported Devices

Monitoring Examples

What Can Be Monitored

This MIB depends on

Related MIBs

RFC description