All MIBs › TPLINK-STATICROUTE-MIB
Organization: TPLINK
Last Updated: 2012-12-13
Category: IP Routing and Multicast
Description: Manages TP-Link switch static route destinations, next-hop gateways, and administrative distances.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is TPLINK-STATICROUTE-MIB?
TPLINK-STATICROUTE-MIB is a TP-Link private enterprise MIB for configuring static unicast routes on TP-Link managed switches/routers, covering destination networks, next-hop gateways, and administrative distance values for manually defined routes. It exposes purely configuration-category data describing the device's static routing table entries. Its monitoring value is largely a configuration-audit one: an administrator polls it to confirm a static route to a critical destination is still present and pointing at the correct, reachable next hop, since a missing or altered entry would cause otherwise-unexplained reachability loss. It sits alongside the device's dynamic routing protocols and standard IP-MIB/routing-table objects as one source of truth for the forwarding table. It is used in smaller or cost-sensitive network deployments where static routing is preferred over running a dynamic routing protocol on TP-Link Layer 3 switches or routers.
IPNetwork Monitor allows you to monitor SNMP objects defined in TPLINK-STATICROUTE-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- TP-Link managed switch or router
Monitoring Examples
No specific object or table names were provided in the source excerpt for this module, so concrete identifiers cannot be cited. A static route MIB of this kind would expose a table of destination network/mask pairs with next-hop address and administrative distance; an administrator would poll it after a reachability complaint to confirm the expected static route to a remote subnet is still configured with the correct next-hop gateway, rather than having been accidentally deleted, and can download the TPLINK-STATICROUTE-MIB file directly to load its object definitions into a MIB browser for reference.
What Can Be Monitored
- static route destination entries
- next-hop gateway addresses
- administrative distance values
Imported Objects
From SNMPv2-SMI
| IpAddress | |
| OBJECT-TYPE |
From TPLINK-MIB
| tplinkMgmt | OBJECT-IDENTITY |
From TPLINK-TC-MIB
| TPRowStatus |
OIDs
RFC description
TP-Link static route configuration for fixed network topology routing policy.
Start monitoring TP-Link managed switch or router (static unicast route config status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.