All MIBs › NETGEAR-SFLOW-MIB
Organization: Netgear Inc
Last Updated: 2012-01-12
Category: Switch Management, Traffic Shaping
Description:
Manages sFlow packet sampling configuration, collector targets, and sample export on Netgear switches.
Imported Objects
From IF-MIB
| InterfaceIndexOrZero |
From QUANTA-LB6M-REF-MIB
| lb6m | OBJECT-IDENTITY |
From SNMPv2-SMI
| Integer32 | |
| MODULE-IDENTITY | |
| OBJECT-TYPE |
What Is NETGEAR-SFLOW-MIB?
NETGEAR-SFLOW-MIB is a private Netgear FastPath MIB for configuring sFlow packet sampling, which exports statistically sampled packet headers and interface counters to a remote sFlow collector for traffic analysis. No sample objects were provided in the source material, so specific object/table names cannot be enumerated, but an sFlow configuration MIB of this kind would typically expose sampling rate, polling interval, and collector destination address/port objects, often per-interface. Its monitoring relevance is in confirming sFlow is correctly configured and actively exporting samples to the intended collector, which underpins broader traffic visibility and anomaly detection performed by the external sFlow analysis tool. It is an implementation of the industry-standard sFlow (RFC 3176) protocol layered as a Netgear-specific configuration MIB. It is deployed on Netgear FastPath-based managed switches used in networks with centralized traffic-flow monitoring. Engineers can download the NETGEAR-SFLOW-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in NETGEAR-SFLOW-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Netgear FastPath-based managed switch
Monitoring Examples
No sample objects were provided for this MIB, so a concrete polling scenario referencing real object names cannot be constructed from the available material. In general, an sFlow configuration MIB would be checked to confirm the sampling rate and collector IP/port are correctly set so that traffic samples are reaching the intended sFlow analyzer, but specific object names are not confirmed here.
OIDs
| OID symbolic | OID numeric | Type | Access | Description |
|---|---|---|---|---|
| fastPathSflow | 1.3.6.1.4.1.4526.10.59 | The Netgear Private MIB for FastPath SFLOW | ||
| agentFastPathSflowObjects | 1.3.6.1.4.1.4526.10.59.1 | |||
| NUM agentSflowSourceInterface | 1.3.6.1.4.1.4526.10.59.1.1 | InterfaceIndexOrZero | read-write | A source-interface selection on an Interface Index (like vlan based routing interface, port based routing interface, loopback interface, tunnel interface). A non-zero value indicates ifIndex for the corresponding interface entry in the ifTable is selected. A zero value indicates source-interface is un-configured. |
RFC description
Configures sFlow (sampled flow) monitoring on Netgear FastPath switches with source interface selection.
Start monitoring Netgear FastPath-based managed switch (sFlow packet sampling) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.