All MIBs › ISM-TRAP-MIB
Organization: Huawei Technologies Co.,Ltd.
Last Updated: 2013--0-4-
Category: Alarm and Event Management, Domain: Storage, Vendor: Huawei
Description: Huawei ISM trap MIB defining SNMP notification objects for storage system fault events and threshold alerts.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ISM-TRAP-MIB?
ISM-TRAP-MIB is a Huawei vendor MIB defining SNMP trap notifications for its ISM (storage management) platform, intended to alert on storage system fault conditions and threshold crossings. The module description available is minimal, but based on its naming and category it is expected to expose event-driven notifications rather than pollable status objects, covering hardware faults such as disk or controller failures and software-level threshold alerts. Its practical use is exclusively in fault/event monitoring: alerting an operator in near real time when a storage subsystem component fails or a monitored metric crosses a configured threshold, complementing whatever base ISM MIB provides for steady-state polling. It likely depends on a companion Huawei ISM base MIB for the object definitions referenced by its traps, though that dependency is not explicit in the available extract. Deployment context is Huawei storage systems (e.g., enterprise SAN/NAS arrays) managed via Huawei's ISM software. Network engineers evaluating or troubleshooting this functionality can download the ISM-TRAP-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in ISM-TRAP-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Huawei storage systems (SAN/NAS arrays)
Monitoring Examples
No sample object names were provided in the source extract for this module, so specific trap or varbind identifiers cannot be responsibly invented. Based on the module's naming and short description, a realistic scenario would be receiving a trap when a Huawei storage array reports a fault event or threshold alert, prompting the operator to check the storage array's health directly. Without concrete object names, further detail would be speculative.
Imported Objects
From SNMPv2-CONF
| MODULE-COMPLIANCE | |
| NOTIFICATION-GROUP | |
| OBJECT-GROUP |
From SNMPv2-SMI
| Counter64 | |
| Gauge32 | |
| Integer32 | |
| IpAddress | |
| MODULE-IDENTITY | |
| NOTIFICATION-TYPE | |
| OBJECT-TYPE | |
| Unsigned32 | |
| enterprises |
From SNMPv2-TC
| RowStatus | |
| TEXTUAL-CONVENTION |
OIDs
RFC description
Huawei Integrated Storage Manager SNMP trap definitions for storage system event notification.
Start monitoring Huawei storage system (SAN/NAS array, trap notifications) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.