| OID symbolic | OID numeric | Type | Access | Description |
|---|
| hwRPR | 1.3.6.1.4.1.2011.5.25.36 | | | The HUAWEI-RPR-TRAP-MIB contains objects to
Monitor the RPR TRAPs.
*********************************
RPR TRAP
**********************************
This RPR TRAP consists of the following TRAPs:
1 : hwRPRexcessReservedRateDefect
2 : hwRPRprotMisconfigDefect
3 : hwRPRtopoChange
4 : hwRPRtopoInvalidDefect
5 : hwRPRduplicateMacAddressDefect
6 : hwRPRtopoInstabilityDefect
7 : hwRPRtopoStabilityRestore
8 : hwRPRPhyIfEventTrap
9 : hwRPRLogicIfEventTrap |
| hwRPRObjects | 1.3.6.1.4.1.2011.5.25.36.1 | | | |
| hwRPRIfEventTable | 1.3.6.1.4.1.2011.5.25.36.1.1 | | not-accessible | A table of interface event information. |
| hwRPRIfEventEntry | 1.3.6.1.4.1.2011.5.25.36.1.1.1 | | not-accessible | Interface event information Entry. |
| NUM hwRPRLogicIfIndex | 1.3.6.1.4.1.2011.5.25.36.1.1.1.1 | InterfaceIndex | accessible-for-notify | The ifIndex of this RPR logic interface. |
| RPR hwRPRLogicIfSpanId | 1.3.6.1.4.1.2011.5.25.36.1.1.1.2 | RprSpan | accessible-for-notify | The SpanId of this RPR logic interface. |
| INT hwRPRLogicIfEvent | 1.3.6.1.4.1.2011.5.25.36.1.1.1.3 | INTEGER | accessible-for-notify | Type of logic interface event.
SD indicates that SDH Signal of the RPR logic interface degrades;
SF indicates that SDH Signal of the RPR logic interface fails;
MATEERR indicates that mate cable error caused by mate cable of
the RPR physical interface is linked incorrect; |
| INT hwRPRPhyIfEvent | 1.3.6.1.4.1.2011.5.25.36.1.1.1.4 | INTEGER | accessible-for-notify | Type of physical interface event.
SDHFramerSDst indicates that SDH Signal of the RPR physical interface degrades;
SDHFramerSFst indicates that SDH Signal of the RPR physical interface fails;
SDHFramerLOSst indicates that SDH Signal of the RPR physical interface loses;
SDHFramerLOFst indicates that SDH framer of the RPR physical interface loses;
SDHFramerRDIst indicates that remote Defect Indication ;
SDHFramerAISst indicates that alarm Indication Signal;
SDHFramerREIst indicates that remote ErrorIndication;
Miscabling indicates that cable of the RPR physical interface is linked incorrect;
Keepalive indicates that an exchange of messages allowing verification
that communication between stations is not active;
MateState indicates that mate cable of the RPR physical interface is linked incorrect. |
| hwRPRIfConfigTable | 1.3.6.1.4.1.2011.5.25.36.1.2 | | not-accessible | A table of RPR logic interface configuration information. |
| hwRPRIfConfigEntry | 1.3.6.1.4.1.2011.5.25.36.1.2.1 | | not-accessible | RPR interface Configuration entry. |
| NUM hwRPRIfConfigIfIndex | 1.3.6.1.4.1.2011.5.25.36.1.2.1.1 | InterfaceIndex | not-accessible | The ifIndex of this RPR logic interface. |
| INT hwRPRLogicIfTotalBandWidth | 1.3.6.1.4.1.2011.5.25.36.1.2.1.2 | INTEGER | read-write | The total bandwidth of this RPR logic interface. |
| hwRPRTraps | 1.3.6.1.4.1.2011.5.25.36.2 | | | |
| NTF hwRPRexcessReservedRateDefect | 1.3.6.1.4.1.2011.5.25.36.2.1 | | | This defect indicates that the amount of reserved
bandwidth on a ringlet exceeds the available LINK_RATE.
When an excess reserved rate defect is present,
a notification may be generated. |
| NTF hwRPRprotMisconfigDefect | 1.3.6.1.4.1.2011.5.25.36.2.2 | | | A critical severity defect that indicates the presence
of mismatched-protection-configuration stations, based
on the value returned by MismatchedProtection().
When a protection configuration defect is present
on the station, a notification may be generated. |
| NTF hwRPRtopoChange | 1.3.6.1.4.1.2011.5.25.36.2.3 | | | When an topology change is present,
a notification may be generated.. |
| NTF hwRPRtopoInvalidDefect | 1.3.6.1.4.1.2011.5.25.36.2.4 | | | A critical severity defect indicating that an
invalid entry has been found within the scope
of the topology,the stations on the ring excess
the MAX_STATIONS or the local station has one
or more duplicate secondary MAC addresses. When
a topology entry invalid defect ,exceeing MaxStations
or duplicate secondary MAC addresses is present,
a notification may be generated. |
| NTF hwRPRduplicateMacAddressDefect | 1.3.6.1.4.1.2011.5.25.36.2.5 | | | A critical severity defect indicating that a
duplicateMacAddress has been found on the ring.
When a duplicateMacAddress defect is present,
a notification may be generated. |
| NTF hwRPRtopoInstabilityDefect | 1.3.6.1.4.1.2011.5.25.36.2.6 | | | The critical severity Instable topology defect.
When an Instable topology defect is present,
a notification may be generated. |
| NTF hwRPRtopoStabilityRestore | 1.3.6.1.4.1.2011.5.25.36.2.7 | | | The critical severity Instable topology restore.
When an stable topology is present,
a notification may be generated. |
| NTF hwRPRPhyIfEventTrap | 1.3.6.1.4.1.2011.5.25.36.2.8 | | | The critical severity physical interface defect.
When an physical interface defect is present,
a notification may be generated. |
| NTF hwRPRLogicIfEventTrap | 1.3.6.1.4.1.2011.5.25.36.2.9 | | | The critical severity Logic interface defect.
When an logic interface defect that caused
by physical interface event is present,
a notification may be generated. |
| NTF hwRPRNodeConErr | 1.3.6.1.4.1.2011.5.25.36.2.10 | | | On RPR ring, to detect the connection, a kind of packet
is send between neighbor RPR nodes, This kind of packet
is SC(Single-Choke) packet, If a node cannot receive SC
packet from neighbor node in KEEPALIVE time, then there
is failure between the two nodes. When happened, auto protection
is executed by software.! |
| NTF hwRPRNodeConErrResume | 1.3.6.1.4.1.2011.5.25.36.2.11 | | | On RPR ring, to detect the connection, a kind of packet
is send between neighbor RPR nodes, This kind of packet
is SC(Single-Choke) packet, If a node cannot receive SC
packet from neighbor node in KEEPALIVE time, then there
is failure between the two nodes. When failure is resumed
, this notification is sent.! |
| NTF hwRPRNodeMisCabling | 1.3.6.1.4.1.2011.5.25.36.2.12 | | | Optical fiber is connected in error. i.e the east direction
of one node is connected with east direction of another node,
or the west direction of one node is connected with west direction
of another node! |
| NTF hwRPRNodeMisCablingResume | 1.3.6.1.4.1.2011.5.25.36.2.13 | | | when phenomena that Optical fiber is connected in error disappears,
this notification is sent! |
| NTF hwRPRMateErr | 1.3.6.1.4.1.2011.5.25.36.2.14 | | | In double RPR operating mode, east and west directions
of one rpr node lay on two RPR cards, These two cards are
internally conntected by Gigaibit-ethernet, which is called
MATE interface. The RPR nodes cannot work normaly under
condition of MATE error.! |
| NTF hwRPRMateErrResume | 1.3.6.1.4.1.2011.5.25.36.2.15 | | | In double RPR operating mode, east and west directions
of one rpr node lay on two RPR cards, These two cards are
internally conntected by Gigaibit-ethernet, which is called
MATE interface. The RPR nodes cannot work normaly under
condition of MATE error.when MATE error is resumed ,this
notification is sent! |
| NTF hwRPRLOS | 1.3.6.1.4.1.2011.5.25.36.2.16 | | | On RPR physical layer, link connection is detected
through physical singal. When can't receive physical
singal, then local node from neighbor node, LOS(lost of signal)
alarm is report, auto protection is executed by software.! |
| NTF hwRPRLOSResume | 1.3.6.1.4.1.2011.5.25.36.2.17 | | | On RPR physical layer, link connection is detected
through physical singal. When can't receive physical
singal, then local node from neighbor node, LOS(lost of signal)
alarm is report, auto protection is executed by software.when LOS
is resumed,this notification is sent |
| hwRPRTrapConformance | 1.3.6.1.4.1.2011.5.25.36.3 | | | |
| hwRPRTrapCompliances | 1.3.6.1.4.1.2011.5.25.36.3.1 | | | |
| hwRPRTrapCompliance | 1.3.6.1.4.1.2011.5.25.36.3.1.1 | | | The compliance statement for entities that implement
RPRTRAP on a router. |
| hwRPRTrapGroups | 1.3.6.1.4.1.2011.5.25.36.3.2 | | | |
| hwRPRIfEventGroup | 1.3.6.1.4.1.2011.5.25.36.3.2.1 | | | provide RPRTRAP objects configuration information. |
| hwRPRTrapGroup | 1.3.6.1.4.1.2011.5.25.36.3.2.2 | | | Required objects to provide RPRTRAP objects configuration
information. |
| hwRPRIfConfigGroup | 1.3.6.1.4.1.2011.5.25.36.3.2.3 | | | Description. |
